 |
|
|
 |
New Member
|
|
Jun 26, 2009, 04:57 AM
|
|
Nordyne not cooling
We just had our Nordyne unit charged with freon and a sealant put into it one month ago. Unit is not cooling. Condenser is running. Could it be the relay?
|
|
 |
Ultra Member
|
|
Jun 26, 2009, 05:42 AM
|
|
The outdoor is runinng? Fan and compressor? COuld be out of freon again
|
|
 |
New Member
|
|
Jun 26, 2009, 05:54 AM
|
|
 Originally Posted by Joshdta
the outdoor is runinng? fan and compressor? COuld be out of freon again
If I hadn't had them put the can of sealant in I would think so, however, my understanding is that the sealant stays in the system forever filling pin holes. But I should check to see if the compressor is coming on. I know the fan is, that's obvious but let me see if I hear the compressor and I will let you know. Thank you
|
|
 |
Ultra Member
|
|
Jun 26, 2009, 05:59 AM
|
|
Some times the seal will cause the compressor not to run, yon may need a hard start kit, also if the leak was bigger then anticapated it may have not sealed and the freon has leaked again.
|
|
 |
New Member
|
|
Jun 26, 2009, 06:06 AM
|
|
 Originally Posted by Joshdta
some times the seal will cause the compressor not to run, yon may need a hard start kit, also if the leak was bigger then anticapated it may have not sealed and the freon has leaked again.
Right, I am with you about if it were a big leak. The fan is turning on the compressor but I don't hear the normal "humm" it sounds different, a little bit rattley. Maybe I should try the hard start kit. If I do have a bigger leak, I know that probably means new unit, but if I try the hard start kit would that be a "no harm no foul" if it doesn't work
|
|
 |
Ultra Member
|
|
Jun 26, 2009, 12:30 PM
|
|
Yes try it first most companys carrie them on the trucks
|
|
 |
New Member
|
|
Jun 26, 2009, 04:32 PM
|
|
Thank you for all your help today. Connections on the compressor were corroded. Cleaned them up. Installed new capacitor and new contactor and we are bringing in 61 degrees of some much needed air. Thanks for sticking with me.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Nordyne heater
[ 3 Answers ]
Indicator Light blinking twice shows pressure switch is open will not allow blower or heat to work.
Nordyne short
[ 1 Answers ]
I FOUND THE SHORT!! Guys. Thanks for the tips. In the process of ringing through everything I found the problem in the limit switch. When I went from one of the connectors to the cabinet, ring ring... dead short. Took out the switch and on the inside, the tabs that the switch was mounted to, the...
Nordyne heater won't come on
[ 6 Answers ]
I have a nordyne electric heater model E1EH-020HA that will noy come on. The a/c works fine but when I turn to heat nothing comes on, not the blower or the heat strips. I changed the thermostat but it did not fix my problem. What should I do now? Thanks, gts
Mobile home cooling unit not cooling
[ 1 Answers ]
We recently purchased a couple of mobile homes for rental properties. When we hade them inspected they said everything was in working order. When we moved in a tenet the first thing they complained about was that the a/c was not cooling during the day, but at night it was fine. We sent out a...
Nordyne air&heat
[ 2 Answers ]
Wireing diagram for thermostat&heat strips 1-5kw 1-10kw
View more questions
Search
|