Ask Experts Questions for FREE Help !
Ask
    mike langran's Avatar
    mike langran Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 21, 2009, 05:34 PM
    Kirkland propane dryer
    Dryer will not ignite. Checked the regulator: is good .the igniter is good. Can't seem to find the problem
    Perito's Avatar
    Perito Posts: 3,139, Reputation: 150
    Ultra Member
    		  
    #2

    Jun 21, 2009, 07:58 PM

    Is power getting to the ignitor? Does the ignitor get hot? If not, you need to trace through the thermostat(s) and interlocks to see where the power "disappears".

    If the ignitor is getting hot, then it's probably the gas valve. Is there power to the valve? If not, you need to trace that down. If there is power to the valve, the valve or the coil that operates the valve is likely faulty.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane kirkland dryer won't stay lit [ 1 Answers ]

My kirkland propane dryer does not stay lit. It lites for 12 seconds and just goes out. Stays out till the end of the cycle ors lite again for 12 seconds.

Kirkland Signature Dryer [ 1 Answers ]

I have a Kirkland Signature Dryer and the rotating barrel seems to have fallen. This is causing my clothes to get stained by what seems like grease. Any idea whether this can be fixed or do I need to replace it? Any information would be valuable. Thanks

Kirkland dryer [ 2 Answers ]

I have a Kirkland Dryer and inside the dryer is the plastic device that is suppose to separate the clothes. It has come away from the dryer itself and I am wondering the best way to get that piece attaced again. It screws on, I just need to know if the top of the dryer pops up or if I need to go...

View more questions Search