Ask Experts Questions for FREE Help !
Ask
    lulualoha's Avatar
    lulualoha Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 5, 2007, 04:27 PM
    Kirkland dryer
    I have a Kirkland Dryer and inside the dryer is the plastic device that is suppose to separate the clothes. It has come away from the dryer itself and I am wondering the best way to get that piece attaced again. It screws on, I just need to know if the top of the dryer pops up or if I need to go through the back of the dryer. Any directions would be so helpful, as my laundry is backing up:o
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 5, 2007, 04:43 PM
    You should see a seam about 1 " below the top surface. Wedge a putty knife or table knife into the seem and try prying up. Move the knife a few inches in each direction and pry again. It should pop up. Be careful inside the housing, there are many sharp edges.
    lulualoha's Avatar
    lulualoha Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 5, 2007, 06:06 PM
    Thank you so much for your help!! My clothes are drying as we speak!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kirkland Washing Machine by Whirpool [ 1 Answers ]

My Kirkland washing machine, manufactured by Whirlpool, will fille with water, but the agitator does not work. The machine makes a funny noise, and trying to manually move the agitator does not make a difference.

Kirkland sig whrilpool dryer not heating! [ 2 Answers ]

Well I cleaned it out, its not dirty anyway since I clean the lint after everywash & the lint box on the floor as well, I turn it on, it spins it sounds, it stops on time, but will not heat, it just tumbles my clothes in cold air. Any suggestions? Is the pilot off? (was my first question) is so how...

Whirlpool Kirkland Signature Dryer [ 1 Answers ]

I Have a Whirlpool kirkland signature dryer. It won't start. I set the dial on timer, open the door and push the door sensor and can hear the timer ticking. Reading the post it seems it could be the thermal fuse of the fuse to the door switch. Where are the panels located to open up the unit...

Kirkland Signature by Whirlpool: Freezer racks [ 1 Answers ]

I live in an apartment, and it came with a "Kirkland Signature by Whirlpool" refrigerator, model ST14CKXKQ The freezer has 2 slots for freezer racks, but the freezer racks were gone when I moved in. I've been trying to find out where I can buy replacement racks, but no one seems to carry them....

View more questions Search