Ask Experts Questions for FREE Help !
Ask
    integrajay90's Avatar
    integrajay90 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 13, 2009, 07:54 AM
    I have a 92 honda civic and it has no spark
    My civic would sputtering the first 20 seconds I was driving it and then it would run fine and now it won't start at all. It has no spark what so ever. I have changed the plugs, wires, cap, rotor, distributor, coil pack, ignition modulator, fuel filter, and the ckp sensor. What should I do I have run out of ideas give me some ideas!!
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Jun 13, 2009, 08:28 AM

    Check all under dash and under hood fuses with a test light or multimeter:

    https://www.askmehelpdesk.com/cars-t...tml#post265896

    If the CEL comes on and goes out normally, the problem is likely distributor-related. Since it sounds like you attempted to replace the internal CKP Sensors, I would buy a genuine Honda distributor housing and install your new ICM, coil, rotor, and distributor cap. We have had many problems with even new aftermarket distributors for Hondas not working.
    civicman13's Avatar
    civicman13 Posts: 1, Reputation: 1
    New Member
     
    #3

    Jun 18, 2009, 11:54 AM
    Quote Originally Posted by TxGreaseMonkey View Post
    Check all under dash and under hood fuses with a test light or multimeter:

    https://www.askmehelpdesk.com/cars-t...tml#post265896

    If the CEL comes on and goes out normally, the problem is likely distributor-related. Since it sounds like you attempted to replace the internal CKP Sensors, I would buy a genuine Honda distributor housing and install your new ICM, coil, rotor, and distributor cap. We have had many problems with even new aftermarket distributors for Hondas not working.
    Ok check your starter by putting channel locks up to the two bolts and if it sparks then you know that then its not the starter it's the other black wire with a pig nose inlet. If you find that then make you own wire setep like I did. I ran a red line going on the starter prong, then I ran the other end to the gattery, then I ran another wire to a twoggle switch that I put in the dash.
    cowdough's Avatar
    cowdough Posts: 23, Reputation: 2
    New Member
     
    #4

    Jun 20, 2009, 04:42 AM

    Test engine codes...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

93 Honda Civic No Spark [ 3 Answers ]

Is it possible someone tried to short out my alarm system by grounding out my car, then tapping with hot cable from another battery? My car was fine when parked night before. In the morning, it wouldn't start. I found a blown 50 amp IG fuse in engine compartment, replaced it, charged my battery;...

Honda civic no spark [ 1 Answers ]

I found my distributor fried so I replaced the distributor and cap . Still no spark . What next ?

NO spark 92 Honda Civic LX [ 1 Answers ]

92 honda civic cranks this. Router turns no spark replaced this. Cap and router and in moud in this. What should I LOOK FOR

Honda civic - no spark [ 1 Answers ]

My 1992 civic is cranking but not starting, and upon inspection it isn't getting any spark. Any ideas where to look?

90 honda civic no spark [ 4 Answers ]

My 90 civic has no spark believe it is the ignition ignitor but my ECU tells me it is the fuel injection system(code 16). I tested the main relay, ignition coil(both good), and replaced the rotor and cap. Still no spark, so reading other posts I believe it to be the ignitor. But the ECU thing is...


View more questions Search