Ask Experts Questions for FREE Help !
Ask
    Jim2929's Avatar
    Jim2929 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 14, 2006, 08:22 AM
    Dishwasher - water murky after wash
    After washing a load of dishes, my four year old Whirlpool dishwasher usually has murky looking water in the bottom. The dishes look clean but their final rinse was obviously with this murky water which is unappealing at best.

    I have an airgap, which is connected into the disposal, but the airgap doesn't come out above the sink. Instead, it is strapped up as high as it can go under the sink. From what I have read, that shouldn't be a problem.

    What might be the problem?

    TIA,
    Jim
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Oct 14, 2006, 09:01 AM
    Hey Jim,

    What you're looking at is the sump. This collects the water that runs back down the hose after the pump shuts off. This "sump water" does not get recirculated when you wash a fresh set of dirty dishes. The water being used in the wash ends up in the sump and is pumped out when the cycle ends. While we install dishwashers we do not repair them. I'm going to move this thread over to appliances where the experts there canmgive you a better explanation. Regards, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Ultra Wash Dishwasher [ 1 Answers ]

I have a Kenmore Ultra Wash dishwasher that is approximately 5 years old. About 3 weeks ago the lock light started blinking. I held the No Heat button for 4 seconds to unlock which it did, but still will not start. Now, the delay 2 hour light is constantly blinking and my dishwasher still...

Dishwasher fills with water but does not wash [ 2 Answers ]

I have an old ge dishwasher, a pot scrubber. When I turn it on the water goes in it but nothing else happens. The water spraying thingy does not turn, but it continues to go through the entire cycle including the drying cycle, but all the water is still in the bottom of the dryer. What could be...

Kenmore Ultra Wash dishwasher [ 2 Answers ]

I am looking for a user manual or simply some explanation as to the various controls on the Kenmore Ultra Wash dishwasher. It is an older model #110753613 Serial number FFA0404041 I have done a lot of searching on the net and the only thing I can find is that Kenmore will give you the user...


View more questions Search