Ask Experts Questions for FREE Help !
Ask
    BodeSam's Avatar
    BodeSam Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 3, 2009, 05:28 PM
    Distance between pumps calculation
    Hey.

    I've been searching the internet and some bibliography but I still haven't found clear info about how you calculate the distance between 2 pumps in a pumping system, so far I've found that it relates with the NPHS but what I've read just confuses me more.

    Anyway, thanks for any help :D
    Quantum's Avatar
    Quantum Posts: 38, Reputation: 2
    Junior Member
    		  
    #2

    May 14, 2009, 07:09 AM
    The distance between two pumps relates to the maintanance space required. From experience I can tell you that the distance should be minimum 150% the width of the pump


    Rate me
    oapicado's Avatar
    oapicado Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Jun 18, 2012, 01:04 PM
    En la norma PDVSA IR-M-01, capitulo 7 más especifico en la Tabla 1 se dice cuanto debe ser la distancia entre equipos de un plantel industrial
    [The standard PDVSA IR-M-01, Chapter 7 more specific in Table 1 as it is said to be the distance between equipment in the Industrial]
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Well pumps [ 1 Answers ]

Recommendations on summersible well pumps... Goulds or Franklin motors? Thanks

Circulating Pumps - submersible pumps - low efficiency [ 1 Answers ]

Hello people, Well I was selecting some hot water circulating pumps and submersible pumps, for a rather big project. I consulted GRUNDFOS (can't get bigger than that). For the hot water circulating pumps, Grundfos informed me that the best selection according to my (flow, head)...

Pumps [ 6 Answers ]

Why is it always advisable to start a pump against a closed valve?

Vac pumps [ 5 Answers ]

Just wondering how long do you leave the pump on the condencer? For 1.5 and 2 T I usually leave the pump on for about 20 to 30 min. Yesterday and today I installed 3 - 5 tonns and 3-4 tonnes at a new building . Tomorrow I'll vac them out for about 30 min each. If you don't mind me asking, what's...

Critical Distance is Pipe Length or Literal Distance? [ 2 Answers ]

Is critical distance measurement based on the literal distance from a trap to the vent stack, or the total length pipe from the trap to the vent? In other words, if the trap is 4 feet from the vent, but the drain pipe from the trap to the branch that has the vent connected to it is 10 feet, is the...

View more questions Search