Ask Experts Questions for FREE Help !
Ask
    misscris28's Avatar
    misscris28 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 25, 2009, 08:12 AM
    Bike will not start- no spark
    So I just purchased a chinese Zongshen sierra 200cc brand spankin new from a company in fl. I got it on the road and put about 350miles on it no problems. So I'm riding down the highway going 60mph and all of a sudden my bike just starts coasting, does not shut off completely, but I'm giving it throttle and its not going anywhere. So, I pull over and kill the engine, the bike will now not start up again. There is no spark to the spark plug so I replaced that but it did not fix the problem. Any ideas?
    jrk's Avatar
    jrk Posts: 17, Reputation: 1
    New Member
    		  
    #2

    May 13, 2009, 09:29 AM

    Spark plug wires or the stators.

    Jeremy
    misscris28's Avatar
    misscris28 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    May 13, 2009, 10:33 AM
    Turned out to be the cdi unit
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Car Won't Start - No Spark [ 13 Answers ]

The car is a 1994 Toyota Camry 4cyl automatic. Recently replaced blown head gasket. Car started after repair but ran for only 5 seconds before it died and wouldn't start again. After checking the timing belt and cam positions I cranked the engine and performed a spark test which produced a...

12 HP Briggs won't start, no spark [ 2 Answers ]

12 HP L head twin Briggs 404707 1205 01 Won't start unless you ground one spark plug wire. Put on new coil, same problem?? : Both plug wires on, no spark. Grounded one by accident ( while checking for spark) and engine fired up on other cylinder. Engine runs great once you get it to start. Why...

No start, no spark [ 1 Answers ]

Neighbors Sears riding mower would not restart after shutting it off. Good battery, new plugs new fuel filter. Took top cover off and checked pick up. Noticed that the lead on the coil pick up is worn low. Should if be making contact with the fly wheel to make contact with the magnetic pick-up for...

Got spark STILL won't start [ 1 Answers ]

I have a cutters edge(jonsered) 2 cycle chain saw, I replaced the ignition module and checked for spark, very weak spark and still no start. I took the module off and sanded the mounting surface where the module bolts to and gets a ground, after reinstalling the module I got good spark but it...

View more questions Search