Ask Experts Questions for FREE Help !
Ask
    sunnyd's Avatar
    sunnyd Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Mar 5, 2007, 03:06 PM
    Got spark STILL won't start
    I have a cutters edge(jonsered) 2 cycle chain saw, I replaced the ignition module and checked for spark, very weak spark and still no start.
    I took the module off and sanded the mounting surface where the module bolts to and gets a ground, after reinstalling the module I got good spark but it still will not start, also I noticed when I pull the rope with the plug out the gas is being pushed out of the carb. And past the choke plate ( its coming out of the carb instead of going down into the carb.)
    Please HELP I'm stuck and need the saw to work. Thanks again, Jim :confused: :mad:
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    Mar 5, 2007, 06:31 PM
    Pull the muffler and look for scoring, it may be low compression. Also how is the flocking on the air filter? The saw may have been run with poor air filtration and that will cause unbelievable blow-by out the intake. You may be money ahead by taking it in for an estimate at either a husky dealer or jonsered.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1995 Toyota Tacoma won't start, no spark [ 10 Answers ]

My 1995 Tacoma was ruuning fine when one evening I got in it and started driving from my house. At the end of my street, after turning a corner, the truck simply died! I tried to start it, and nothing! It hasn't started since. I towed it home that night & discovered that it wasn't firing. I've...

Car Won't Start - No Spark [ 13 Answers ]

The car is a 1994 Toyota Camry 4cyl automatic. Recently replaced blown head gasket. Car started after repair but ran for only 5 seconds before it died and wouldn't start again. After checking the timing belt and cam positions I cranked the engine and performed a spark test which produced a...

92 Honda Accord LX won't start,no spark [ 4 Answers ]

My 92 Honda Accord won't start, coil has no spark.the starter cranks fast, I replace the coil, the main relay switch and the ECU module inside the distributer.I used a multimeter to check the battery voltage (12 volts) but the highest voltage going in to the coil is only 1.4 volts. I could use some...

1989 Honda civic won't start! ( No SPark) [ 13 Answers ]

Hi everybody, My name is Leeboy! I am building or finished building a 1989 Honda civic entry level stock car for my girlfriend. I took all interior parts out( I left all the original wiring and harness for at this level we have to have lights and keep everything in original order) and installed a...

Civic 2000,fuel and spark, no start [ 4 Answers ]

I have a 2000 Civic 1.6 ,single cam ,that quit running.Engine turns over,good battery,fuel pump runs,injectors get fuel and signal to open and close.Also, it has spark and the engine timing is fine, but it does not start.Any help would be appreciated.Thanks

View more questions Search