Ask Experts Questions for FREE Help !
Ask
    hillbilly01's Avatar
    hillbilly01 Posts: 3, Reputation: 1
    New Member
     
    #1

    Apr 23, 2009, 07:51 PM
    Troy Built Pony problems
    I have an '07 troy built pony. It keeps burning the belts off. Seems to slip only when the pto is not engaged. There is no tension on the belt. The smoke is coming from the crank pulley.
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
     
    #2

    Apr 23, 2009, 08:44 PM

    If smoke is coming from the crank pulley then the belt is to tight when PTO is off. It sounds partially engaged by too much tension or you may have it on wrong.

    A new belt is not stretched and an adjustment on the tension pulley would be my attack. Even though the springs on the tensioner move some its position starts in the wrong position because of a new belt being a tad smaller. Like a tweak for an alternator when a new belt is put on.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy built, "pony", drive belt replacement [ 2 Answers ]

To better access the drive belts, can the mower be tilted "front up" 'back down" on the ground? Will fuel and oil leak? Any other pointers?

Troy Built electric clutch problems [ 1 Answers ]

I have a Big Red Troy built. Factory clutch burned out. Melted wiring on clutch to the point that plastic ran down into clutch and fused it together. Two other clutches have been put on this mower and the same thing has happened. Didn't even make it around the yard till each one burned up. To...

Troy built pony mower won't start [ 2 Answers ]

Troy built pony riding moerw stalled when the bade bearing frioze up, changed bearinf housind ,blade and belt ,will not even click the starter--where is the blade safety swith located so I can check it ?

Troy built pony tractor smoking [ 3 Answers ]

I have a troy built pony tractor about 2.5 years old, been used very little,yesterday while mowing it started blowing a tremendous amount of smoke from the exhaust while the blades were engaged I disengaged the blades and the smoke stopped, but if you engage the blades it smokes badly and the...


View more questions Search