Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How much Glyco do I need in my Radiant floor?
[ 8 Answers ]
We had a leak in our radiant floor heating system (pressure relief valve) that we had fixed, but we lost most of the original fluid that was in the system. It has an auto fill valve on it so it refilled with tap water as the fluid leaked out. Now we find that we spots in the floor that freeze...
In floor radiant heat vs. Hot water base board
[ 2 Answers ]
I recently bought a home built in 1960 which is heated by hot water base board heat. I am currently renovating the house and am looking at the possibility of installing in floor radiant hot water heat for the second floor. I would install this in the floor joists in the basement before I finish the...
Wiring radiant floor heat
[ 2 Answers ]
I'm considering putting radiant heat in my bath since I've got it down to the bare bones for a remodel. I've read that each square foot of mat draws .1 amp. I'll be installing approximately 12 square feet of mat, equaling 1.2 amps. Can I tap into an existing circuit for this little of a draw?
Radiant Floor Heating
[ 2 Answers ]
I purchased a ranch house with natural gas radiant floor heating. It takes about 4 hours to reach my set temperature. Then it overshoots the temperature. Once it gets back down to the set temperature, the concrete (with embedded copper pipes) is cold again, which means another 4 hours to get... View more questions Search
|