Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Heating & Air Conditioning (https://www.askmehelpdesk.com/forumdisplay.php?f=150)
-   -   Radiant floor heat (https://www.askmehelpdesk.com/showthread.php?t=342152)

  • Apr 15, 2009, 09:28 PM
    hvacservicetech_07
    Radiant floor heat
    Anyone have any experience with repairing busted pex tubing under a slab? I have a customer that would like to fix it without busting up the entire back porch,it's brand new,stamped and very expensive. Any help would be great,I just need to locate it to cut out a small square.
  • Apr 15, 2009, 09:36 PM
    hvac1000
    Many years ago I use a sonar type piece of equipment to find a leak under concrete. The closer I got the louder the noise in my head phones. You have to have water flowing so the sonar picks up the noise.

    I would check with the manufacturer of the tubing to see if they offer a splice kit for under slab. Usually these kits have a special crimp ring that will not be damaged by the minerals/chemicals in the concrete itself. It will not be a fun job and you will find you might have to have a large area to work in for the splice.

    OR

    Depending upon how the system was piped (how many loops) You might be able to disconnect the problem loop and raise the water temp a bit to compensate.
  • Apr 15, 2009, 09:48 PM
    hvacservicetech_07

    This is a new house,it has been a nightmare since day one. The system has four separate zones: basement,small driveway area,front enclosed porch and back covered porch. Both the driveway and back porch have major leaks, when the zones are open the boiler builds no pressure at all,I'm thinking it may be busted right through the basement wall. I came in at the end so I'm not real sure how the pex is laid. I was just curious if you had any tricks,busting up the entire pad is almost not an option.
  • Apr 16, 2009, 05:11 AM
    Joshdta

    If you did not install the pex and the person who did, did not make any digram of the instulation. This is going to be very hard projuct. Last one I did ended up cutting out a 3 x 3 square in the floor.
  • Apr 16, 2009, 03:02 PM
    hvacservicetech_07

    One of our installers put the system in,He has since quit,now I'm left to try and figure this thing out. I thought someone may have some tips on locating the break,it looks like busting up the pad is the only option.
  • Apr 16, 2009, 11:14 PM
    hvac1000
    Here was your tip

    Many years ago I use a sonar type piece of equipment to find a leak under concrete.

    Plumbers have access to this type equipment.

  • All times are GMT -7. The time now is 03:12 PM.