Not your question?
Ask your question
View similar questions
Check out some similar questions!
Replacing J bend
[ 13 Answers ]
I have two masters degrees but I can't seem to understand how to replace a simple j bend under bathroom sink. The old metal pipe has a large hole in it, and basically just fell off when I began to loosen the nuts. I tried replacing the metal with a plastic j bend from Walmart. I don' think there...
Which closet bend to use?
[ 6 Answers ]
I see these three from Mueller, but the pictures all look the same, and the descriptions are all the same... which do I want? Muellar #53105 4x3 HxSpg Closet Bend - SHOP.COM Muellar #03107H 4x3 HxSpg Clos Bend - SHOP.COM Muellar #53108 4x3 HxSpg Clos Bend/Cap - SHOP.COM
Is a closet bend really necessary?
[ 4 Answers ]
Hello, I'm new here and have found this site quite informative while lurking over the past couple of weeks. I am in the process of converting a small office and guest room into a downstairs master bedroom/bath. I am trying to settle on a DWV layout that is simple and hopefully up to code. I...
Closet bend necessary
[ 3 Answers ]
I am remodeling the bathroom and want to put a new flange on the toilet. The old one is cast iron with oakum? And lead connection to the closet bend. I would like to change to ABS but all the fittings (closet bends) that I find at the retail stores are too deep (>8 in to bottom) and put me below...
Lead bend
[ 7 Answers ]
My master bath had a leak at the toilet so I pulled the toilet up and found that the closet flange and the lead bend where no good. The lead pipe is so bent and you can allmost put your finger threw it the lead bend goes into a cast pipe and I would like to replace the bend if anyone has a clue on... View more questions Search
|