Ask Experts Questions for FREE Help !
Ask
    69skydiver's Avatar
    69skydiver Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 10, 2009, 09:32 AM
    Replacing a Blower Moror
    I need to replace a GE Model 5KSP29KK 1892-S blower motor. I went to the local Granger Store and they sold me a replacement motor (AO Smith Model ONR6026). The problem I face is that the original had 4 wires (Black, White, Red, Yellow) of which only the Black, Red, and White were connected. The replacement motor has just two wires and both are black. It also has a connector on the end of the wire. Is this a viable replacement? Was the original a multi speed motor? I know the replacement they sold me is a single speed.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Mar 10, 2009, 09:51 AM
    You had a multispeed motor and they sold you a single speed? Why ? Looks like they made a mistake. Get the correct motor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing a 3 wire GE furnace blower motor with a newer Dayton 4M098G multi speed mo [ 1 Answers ]

My GE furnace blower was a very simple, 5 wire installation, which the bearings wore out on. I am now truing to convert the wiring to adapt to my older furnace, and the new motor has more wires, and different color wires, and the schematic on the motor is too simple, it does not address the...

Replacing A/C Handler/Blower [ 1 Answers ]

When replacing above, does everything else have to be replaced such as the thermostat, inside blower, etc. I've been told that if you have different makes, it will not work properly and/or it will not be energy efficient and could make for higher bills... Fact or Fiction? Thankx.

Blower not working and blower running all the time [ 2 Answers ]

I have a Lennox electric furnace that's about 10 years old or so, the elements come on but no blower. There is a summer fan switch that will make the blower run when switched on, but it will not come on with a call for heat. Also at my work, there is a york gas pack that is probably 15 years old....

Replacing Blower Moter [ 1 Answers ]

I have a Ducane furnace, model#CMPE075U3, for which I have to replace the blower motor only. I have taken off the 4 nuts which seem to hold it in place, but it won't pull out. Is there something in the back holding it on?

Replacing blower motor - matching new to old? [ 2 Answers ]

I just pulled out my old blower motor and am going to replace it. Do I have to match all the specs, i.e. must my new motor be 115v, 1phase, 1050rpm, 1/3hp, 9.9amps, 60hz. Can I/should I choose a motor with greater rpms or greater hp? Thanks for the help, Alex Ps - I decided to replace...

View more questions Search