Ask Experts Questions for FREE Help !
Ask
    mightyaphrodite's Avatar
    mightyaphrodite Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 8, 2008, 05:32 PM
    Replacing Blower Moter
    I have a Ducane furnace, model#CMPE075U3, for which I have to replace the blower motor only. I have taken off the 4 nuts which seem to hold it in place, but it won't pull out. Is there something in the back holding it on?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 9, 2008, 06:01 AM
    It should slide out unless there is a screw in the slide at the top.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blower goes on/off after air conditioner compressor moter was changed [ 4 Answers ]

I have an old Trane Split System Cooling (X149116P01) combined with a gas furnace. The Compressor motor stopped working and was just changed and afterwards, the blower would work fine for a while and then start cycling on and off. When I shut off the system for a while, it would work again for 20...

My Gas Furnace Blower Moter Won't Turn Off [ 4 Answers ]

My furnace is working but the blower motor won't turn off. I can disconnect all of the wires on the thermostat and the motor still runs. The only way I can stop the motor is to either take the face plate off which disengages the switch or to unplug the power cord. I just put a new motor on the...

Blower moter has trouble starting [ 2 Answers ]

Hello. I have an older central Lennox furnace/air conditioner unit that has been giving me trouble lately. I noticed one day that the blower should have kicked on. I went downstairs and found the motor to the blower was humming but the blower was not turning. I flipped the switch on the unit on...

View more questions Search