Ask Experts Questions for FREE Help !
Ask
    davidpwhite's Avatar
    davidpwhite Posts: 25, Reputation: 1
    New Member
     
    #1

    Feb 19, 2009, 09:47 AM
    Dishwasher Cycle Seems Never to End
    I have had (and been happy with) our KitchenAid KUDI01L dishwasher for several years. Recently we moved and have kept the old house for a rental. Renters now report that the dishwasher wash cycle seems never to end (at least not after 2 hours). This is the Normal cycle - not scrub or anything out of the ordinary.

    Yesterday I tried the unit and found that after two hours of running (I could hear the regular noises of washing) I finally hit the cancel button to end the cycle and start draining.

    Any ideas what could be wrong that causes this behavior? Thanks.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Feb 20, 2009, 09:24 AM

    It is likely that the timer motor that advances the cycle is bad. Is this a dial or push buton control panel?
    davidpwhite's Avatar
    davidpwhite Posts: 25, Reputation: 1
    New Member
     
    #3

    Feb 20, 2009, 09:27 AM
    Quote Originally Posted by ballengerb1 View Post
    It is likely that the timer motor that advances the cycle is bad. Is this a dial or push button control panel?
    Actually it is an all-electronic control system. There are only touch-buttons (like on a microwave) and there is no dial at all. I recently looked at the parts list for this unit and did not see any timer motor listed. Thanks for the idea though.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Feb 20, 2009, 09:31 AM

    Sorry Davi, if there is no timer motor I have not worked on this type of unit. If its all digital you might have a bad mother board. Check with these folks to see if it's a computer problem KitchenAid®: Welcome to KitchenAid.com
    davidpwhite's Avatar
    davidpwhite Posts: 25, Reputation: 1
    New Member
     
    #5

    Jul 1, 2009, 10:26 AM
    Just a final update. Finally had a repairman come out. He rapidly discovered that the heating element was bad and replaced it. I always thought that was for drying the dishes. What a surprise! Anyhow, all is well again. Thanks to all.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to fix dishwasher stuck in clean cycle [ 1 Answers ]

Kenmore dishwasher model# 66516034403 stuck in clean cycle. Haw I can reset mashine To work again. Thank you in advance

Dishwasher will not start cycle [ 2 Answers ]

I have an integrated dishwasher - the maunual says Bernstein on the back but I believe it may be a Servis. When you turn it on it drains, then sounds as though it is starting to fill and goint to wash but after about 40-60 seconds stops and gives 2 beeps. It seems to do what it would do when...

Dishwasher won't go through complete cycle [ 1 Answers ]

Hi, I have a kitchen aid dishwasher model kudc25chss1 about 7years old, it won’t complete a cycle, it fills up runs for a second, empties out and repeats the same was for the next cycles. Before I replace the processor board I want to know if it could be another problem. Or is it in the processor...

Leaking dishwasher during cycle [ 1 Answers ]

I have a new Frigidaie 1500 series dishwasher. It leaks water from the bottom of the door on the right and left side. It is not consistent. Sometimes only a few drops- other times a cup or more. The unit is level. Does anyone have experience with this problem?

Dishwasher digital display cycle [ 2 Answers ]

Have a sears Kenmore Ultra II under counter dishwasher. Seems to work fine, however, when it is finished the washing cycle, and is drying, the digital readout shows "LO". Do not have the manual. What does this mean? It seems to be hot when the door is opened, steam comes out and the dishes are...


View more questions Search