Ask Experts Questions for FREE Help !
Ask
    Sponagle43's Avatar
    Sponagle43 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 11, 2009, 10:59 AM
    3/4 h.p. pump control box running 1/2 h.p. pump?
    Will a 3/4 hp submersible pump control box run a 1/2 hp submersible pump?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Feb 11, 2009, 11:06 AM

    Likely. Depends if the box uses overloads which can be changed.

    Provide link to PDF of specs.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Well pump keeps running and is stuck on 25 lbs [ 4 Answers ]

Bought a new well pump, sometimes it goes to 40/60 the proper working pressure, and sometimes after running, it stays at 25 lbs. and keeps on running, when we unplug and plug back in a couple of times, it will catch and go up to proper pressure?

Well Pump stops running [ 6 Answers ]

1) I have a 220V 3 wire submersible pump in my well (30 feet deep) 2) The pressure switch close at 30psi as it is supposed to and the pump begins to run. 3) The pressue rises to about 40psi and the pumps quits for a few seconds and then starts again. 3) The pressure switch remains closed when...

Outside Heat Pump Fan Not Running [ 1 Answers ]

Room temperature (on "cool") air blowing from vents, outside fan on heat pump unit not running. Just had the motor replaced a month ago. What could be the problem?

Should my circulating pump always be running? [ 1 Answers ]

My circulating pump is always running. I have a 3 zone setup and an adjustment dial ranging from 180 to 240 degrees for the circulating pump. It's set to 220. Is that correct and what does it do?

Water pump keeps running [ 3 Answers ]

The water pump to my well doesn't shut off some times. The water pump pressure switch sticks on, either because of the switch or the pressure gauge. If I tap the switch box it will click off. I have shut off the circuit breaker and loosened the nut (on the advice from a plumber). This helps for...

View more questions Search