 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Intertherm elc. Furnace
I Have an intertherm elc. Furnace and sometimes the fan will continue to run after the heating cycle and sometimes it will kick off like it should.
The fan will run for hours until I hit the front of the furnace door then it will kick off immediately. Any idea what the problem is? |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...
The Hot surface ignitor comes on and lights the burner, but goes off after about 9 seconds. It repeats this and then locks out. What could be causing this. Intertherm Furnace: Model #MMHB-56ABHR-01
Hi I have a Intertherm Model MMHA 070ABHr-01 gas. Had a tech out replaced the ignitor/and adjusted it. Problem still is furnace calls for heat prepurge fan motor kicks?? In, ignites runs for 2-3 minutes kicks out fan motor starts runs for 30 sec shuts off. In the mean time the furnace has...
My furnace Intertherm Model # MHHB-077ABHR-06 just starteed kicking the blower in and out. The blower will run for 30 seconds, then stop, about 10 seconds later, it'll kick in again. Sometimes this will go on for 15 minutes. The flame is kicking in and it has electronic ignition.
View more questions Search
|
