Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Twinning error code (but only one furnace)
[ 12 Answers ]
Hi, I just purchased a new control board and the istallation "seemed" very straight forward, i.e. hooking up the various wires from the old board to the new one. However, all I have been able to accomplish is to get a twinning error code, i.e. a rapid red blinking of the diagnostic light. Any...
Intertherm furnace diagnostics code
[ 1 Answers ]
I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on the...
Goodman Furnace Code 8?
[ 1 Answers ]
Hey everyone. I installed a goodman GMH80453 the other day. On the day of install I started and ran it twice with no problems. Now it won't run. Series of events are... Turn up stat to kick it on, inducer fan comes on, runs for about 10 seconds.. Then clicks shuts down and flashes a code 8(which is...
Furnace diagnostic code
[ 1 Answers ]
Concord furnace diagnostics : 3 flashes : Pressure switch is open while inducer is on.
Goodman furnace .code 3
[ 2 Answers ]
:confused: New unit... less than 1 year old... won't start on heat... throws code 3?? View more questions Search
|