Ask Experts Questions for FREE Help !
Ask
Page 2 of 2 « First < 2
    zxed's Avatar
    zxed Posts: 28, Reputation: 1
    New Member
    		  
    #21

    Feb 1, 2009, 03:51 PM

    Here it is :)

    tub drain-vent question
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #22

    Feb 1, 2009, 07:51 PM
    I answered at the posted thread!
Not your question? Ask your question View similar questions
 
Page 2 of 2 « First < 2

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Max. Distance between p-trap and vent stack [ 13 Answers ]

Is there a maximum distance that is allowed between a p-trap for the sink (1 1/2" horizontal pipe) and the vent stack that it drains into (2" or 3" vertical pipe) ? If the distance is more than a couple of feet is it better to put in a separate vent / drain ?

Vent and p trap placement [ 1 Answers ]

I have a modular home and I'am having an addition added on for the kitchen,so I'am moving the sink and all cabinets including the counter out ten feet. I have a crawl space under to run my ptrap down but I don't know where I need to tie in the vent pipe because it's back ten feet in the old wall??

Can vent suck all the water from S trap? [ 4 Answers ]

I'm installing a new shower in a cottage bathroom. THere was no previous shower. I plan to use the same vent that I use for the toilet and sink. The shower is around 10 feet from the vent; the toilet and sink are between the shower and vent. Is it possible for the vent to suck all the water out...

Removing old U-trap [ 8 Answers ]

I'm replacing an old bathroom vanity and the old drain does not line up with the new one. It is centered just fine, but needs to come out from the wall an inch or two. I figured it would be easy to just buy a new trap setup and just replace the old one. Only problem is that I can't remove the first...

Is it trouble if there is no vent or trap on WM branch [ 6 Answers ]

I have a washer drain line, 2 inch diameter stand pipe without a vent or trap. Should I be concerned; I haven't noticed any issues? The stand pipe extends from a wall say 36 inches from the floor, does down; angles away from the foundation, then angles further down directly into the house's...

View more questions Search