Ask Experts Questions for FREE Help !
Ask
    N-BY-NW's Avatar
    N-BY-NW Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 26, 2009, 12:16 PM
    Carrier furnace runs 1 stage of 2 stages for 3 hours
    Carrier model 58mta 9300TS: The furnace will run sometimes it seems like forever without shutting down.. Furnace was installed 03/2004 it just started acting this way lately I have installed a new digital 2 stage thermostat just last week it still acting up... does not want come out of 1st stage of heat anywhere from 45mins. To 4 hours... Any thoughts anybody . Thanks N-BY-NW
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 26, 2009, 03:20 PM
    Check to see if there are any codes being posted by the circuit board. Usually if there is a problem codes will be shown in the number of blinks of the lite on the board. Also after you get the number of blinks there is a legend on the back of the blower door that will tell you what they mean. Post the number of blinks and the legend statement.

    Your owners manual is here

    http://67.52.177.135/Images/upload/p...urnace/om1.pdf
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #3

    Jan 26, 2009, 03:24 PM
    The furnace should be equipped with a diagnostic LED that will blink/flash if a malfunction occurs. If it is a variable-speed unit, the circuit board will store faults in memory for later retrieval. The service label on the unit (usually found inside the front panel) should give a description of various faults and there respective remedies, as well as a description of the procedure for retrieving stored faults if you have a variable-speed unit. What you describe sound like the higher stage isn't working or isn't being activated.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Gas Furnace blower runs on/heat won't come on [ 3 Answers ]

I have a carrier gas furnace model 58DP100 . The fan runs continuously and the gas burners will not ignite ( the pilot is lit ) HELP... please .

Blower fan runs for hours [ 1 Answers ]

I have a Luxaire furnace model PCLU-LD14N100A, the furnace comes on and runs for 10 minutes or so but when the heat shuts off the blower keeps running, the only way to shut it off is to turn off the power switch on the side of the furnace, it doesn't do it every time, only about 25 percent of the...

2 stage furnace / single stage thermostat [ 1 Answers ]

I am having a Goodman 90,000btu 2 stage, variable speed 5 ton blower furnace put in. I am also have a 3 ton 16 seer A/C put in. They want to set me up with a Honeywell 4000 programmable thermostat. I thought that I read that this thermostat was for single stage heating. Am I getting short changed?...

Carrier 2 Stage Gas Furnace Code 33 [ 1 Answers ]

We are having trouble last couple of days now that temp is near 0. The thermostat is calling for heat the furnace runs as follows. It runs on low stage for about 16 minutes and then the high stage turns on for a couple of minutes. The burner then shuts off and the blower shuts off and there is...

No heat, blower runs constantly, carrier gas furnace [ 7 Answers ]

This am we I got up the blower on my carrier series 100 gas furnace (approx 10 years old)was running and blowing out cold air. Even with the thermostat turned to off the blower runs constantly. The only way to stop the blower from running is to turn the switch on the side of the furnace to off or...


View more questions Search