Ask Experts Questions for FREE Help !
Ask
    ajkloos's Avatar
    ajkloos Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 20, 2009, 10:57 AM
    Flame blows out
    I have a goodman furnace. The flame light for about ten seconds the blows out it does three time and then the furnace does not do anything at all. Can you tell me what to do.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 20, 2009, 11:23 AM
    Try this.
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas furnace Cycle Blows but no Flame [ 4 Answers ]

We have a Comfortmaker Furnace that is about 3 years old. It will act like it is going to turn on with the blower moter kicking on but the flame never turns on. Then the motor stops. Then about a minute later it repeats the cycle. It will do this for about 5-7 minutes several times a day. ...

Flame on - fan on - flame goes out [ 1 Answers ]

Thermostat calls for heat, ignitor comes on, burner lights, when hot enough for the fan to come on the burner shuts off. The fan runs for awhile and the ignitor comes back on, lights the burner, runs for a short time and everything shuts off. Then the cycle starts all over again but does not reach...

No flame [ 1 Answers ]

My Trane XE furnace blows cold air. The indicator light blinks 4 times,pause then 4 again.

No flame [ 3 Answers ]

I recently bought a home that's approximately 12 years old. The gas heater seems to be working fine, but no flame. I can smell gas, but it never shuts off unless I turn it off. A few months ago I had a similar problem where the sensor needed to be cleaned. The problem then was produce a...

Flame on! [ 4 Answers ]

Please HELP. I'm having a problem with my furnace rather it's my thermostat it's no responding to the temperature. I replcae it with a new one and it's still the same the second I turn power on the flame and fan blower turns on.What could it be. The wring it's only two wires. W and r.

View more questions Search