Ask Experts Questions for FREE Help !
Ask
    CommonMan's Avatar
    CommonMan Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 16, 2009, 06:48 PM
    Problems with Heating (Gas furnace)
    I've a lennox hot water heating system. It's 3 zone with one circulator pump and three zone valves. The heating on the first floor is fine, but there is no heating on the ground floor (and basement) since last week. There are no bleeders, so we drained the zone near the furnace with no luck. I changed the head of the zone valve (ground floor) with not much success. I switched the thermostats and the one on the ground floor worked on the first floor. So they can be excluded.
    When the thermostat is turned on, the valve mechanism works. There is a clicking sound but the furnace doesn't fire up. Can someone suggest some remedies before I call professional help?
    THanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 17, 2009, 03:00 AM
    The heating on the first floor is fine

    If the heat is fine on the first floor then it will work on all the floors if properly repaired. There should be bleeders on your system and if not I suggest you install them since the only other way to bleed is a pressure power bleed and I do not suggest you attempt that but call for service under those circumstances.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Heating problems with Lennox Furnace [ 2 Answers ]

We have a Lennox Elite Series gas furnace, MN # G23Q3/4 100-2 Model. w/Central Air. The blower comes on and starts blowing cold air and approx 30 minutes to an hour later will blow out warm air. We thought it was a faulty thermostat (White Rogers brand) so we put a new one on. The furnace is...

Heating problems [ 2 Answers ]

I am having trouble with my heater. It kicks on, the burners are lit and the motor is on, but no air comes out the vents. Why is that?

Heating Problems [ 4 Answers ]

Hi. Our heater would not come on this morning. We tried turning it off and then on again but it did nothing. What could be the problems?

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:


View more questions Search