Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Need to buy a new ignitor
[ 2 Answers ]
Around midnight we noticed our furnace had not kicked on in a while, closer looked showed us we were getting an ignitor failure code. After cleaning the flame sensor we are still getting the same error code. Our next step will be to replace the ignitor. The problem is we are not sure where to start...
Cleaning the ignitor
[ 1 Answers ]
I have a Janitrol GUP075-3A furnace. Can you tell me how to clean the ignitor.
Furnace ignitor
[ 1 Answers ]
Hi everyone. I am having a problem with my furnace. The ignitor won't lite the gas. I can lite it with a long match and it works fine until the thermostat cuts it off. I changed the ignitor thinking that was the problem, but it still won't lite by its self. How do I check to see if I am getting...
Need for replacing ignitor
[ 2 Answers ]
At what OHMS reading does the gas furnace ignitor need to be replaced? It is a White Rogers furnace.
1994 Honda Civic Ignitor Removal and Replacement
[ 1 Answers ]
For a 1994 Honda Civic, 1.6l, engine, I am getting no spark and believe the problem to be a bad ignitor in the distributor. The manuals simply say replace it but it is not obvious how to remove it, as there are three small machine screws holding it down for which there is no access. Can anyone... View more questions Search
|