Ask Experts Questions for FREE Help !
Ask
    knifequeen's Avatar
    knifequeen Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 27, 2008, 12:44 AM
    Need to buy a new ignitor
    Around midnight we noticed our furnace had not kicked on in a while, closer looked showed us we were getting an ignitor failure code. After cleaning the flame sensor we are still getting the same error code. Our next step will be to replace the ignitor. The problem is we are not sure where to start looking for a new one. We checked websites for the super mainstream hardware stores but they didn't have anything listed. I know we could order it online somewhere but the problem is we live in Montana and it's been averaging around 5 to 16 degrees. At the moment it's about 65 degrees in the house, shipping claims to take 3 to 9 days. I'm going to be frozen by then.
    Any ideas as to where we should start looking?

    Thanks for your help.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 27, 2008, 01:10 AM
    If you need a part that bad have it shipped overnight express. FedEx and UPS all offer overnight shipping. If I lived that remote from a parts house I would keep one as a spare. The shipping overnight will not cost more if you order 2 at a time. You did not post brand or model number of your unit. You will need those to order the part.




    United States & Canada
    Call Us Toll Free:
    (866) 321-4822
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #3

    Dec 27, 2008, 09:57 AM

    You may also check to see if you have an HVAC/R supplier in your area such as Johnstone Supply or other. Most will not deal with the general public but some will.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No power to ignitor [ 7 Answers ]

Hi; I have a goodman furnace model GMP075-3 and I have no power going to my hot surface ignitor power vent satrts up and I hear the control board click and my voltmeter shows 0.05 and jumps to 0.06 and back to 0.05 when it clicks. I hear the gas valve open and then shut when no flame after...

Cleaning the ignitor [ 1 Answers ]

I have a Janitrol GUP075-3A furnace. Can you tell me how to clean the ignitor.

Hot surface ignitor [ 1 Answers ]

What would cause a hot surface ignitor to explode?

Need for replacing ignitor [ 2 Answers ]

At what OHMS reading does the gas furnace ignitor need to be replaced? It is a White Rogers furnace.

No Ignitor Glow [ 8 Answers ]

Not sure the brand.. When I have the thermostat call for heat the vent blower and the blower both come on and there is no glow.. I have tested and bypassed the limit switches and that doesn't fix the problem. Now the diagnoses light flashes 4 times which is supposed to mean that there is an open...

View more questions Search