Ask Experts Questions for FREE Help !
Ask
    Stephen Bisson's Avatar
    Stephen Bisson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2008, 12:05 PM
    1999 Ford Superduty
    How do you change glow plugs on a 1999 Ford Superduty.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 21, 2008, 01:07 PM

    Removal and installation. With the engine "stone cold," disconnect batteries, remove valve cover, disconnect glow plug connector, remove glow plug with a 10 mm deep socket, install new glow plug (torque to 13 ft.-lbs.), and reattach connector. After finishing the remaining 3 glow plugs on that bank, clean valve cover, install new gasket, and reinstall valve cover (torque to 97 in.-lbs.). Do the same thing for the other bank of glow plugs and reconnect batteries. Not a difficult job--should take several hours.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ford F250 superduty not running right [ 2 Answers ]

I have a 2004 Ford F250 superduty with a 6.0 Powerstroke. I just changed the fuel filters and am having a problem with it running. At idle it runs fine but when I get on it to pull out it misses and puffs white smoke as if there is water in the tank. The water and fuel light is not on but as soon...

Ford Superduty Leaking Master Cylinder [ 1 Answers ]

I have a 2000 Ford f250 Superduty and have been noticing a drips of brake fluid in the cab behind the brake pedal. With a closer look, it appears the "plunger rod" going into the rear of the master cylinder is wet. Can this be fixed with a rebuild or does it have to be outright replaced?

Headlamp 1999 ford f-150 [ 1 Answers ]

How to replace headlamp

Ford F350 Superduty 2005 trouble [ 1 Answers ]

Under heavy loads the turbo squeals /whistles very loud any ideas?

1999 7.3 powerstroke f-350 superduty [ 1 Answers ]

Won't start, I have replaced glow plugs, glow plug controller, both batteries, checked valve cover gasket pluggs, wiring etc... everything is OK and functioning in glow plug system. Still no start. If block heater is plugged in and you use wd-40 in the intake it will start eventually. ...

View more questions Search