Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
My heat won't stop when desired temperature reached
[ 1 Answers ]
Hi, I have 5 electronic zones, each with a separate thermostat, running off a single circulator motor. Two of my zones were heating up way beyond the temperature set on the thermostats. I shut off the thermostats but the zones kept getting heat until I finally turned off the boiler. I've...
A/c shuts off temp never reached
[ 5 Answers ]
My heat pump will run cooling mode for only about 30 min. or so. Then the outdoor unit shuts off. The indoor fan keep blowing. The smaller line going into the evaporator freezes between the evaporator and a valve with a capillairy tube that leads to the larger line. Once it thaws which takes about...
Cycling on-off before desired temp is reached
[ 2 Answers ]
GMP100-3 gas furnace: The furnace runs for 3-5 minutes then shuts itself off for 2-3 minutes then repeats the start- stop cycle. I turned the thermostat up but it still acts the same. Any tips would be appreciate
Furance shuts off before themostat temp is reached
[ 1 Answers ]
Hi, I have a new two stage variable speed lennox furnace, G61V-60C-091. Due to some heating problems right after the install, the company I hired also installed a new white-rodgers programmable thermostat 1F78. Unfortunately even with the new thermostat, I'm having the same problem. At 6:15am,...
Heat not kicking on until the temp dips below 64 degrees, target temp set to 72
[ 2 Answers ]
Hello, This is my first time posting here, but I figured it was a good place to start for some advice. I just bought a new townhouse a few weeks ago and have been having some heating issues since moving in. The actual furnace (Goodman GMS 8045) was installed in June of '06 while the unit was... View more questions Search
|