 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wiring problems
If I wanted to stop humidification during a call for cooling using a step down trans to 24 and not the 24 hum terminals new furnaces have how is it done,using a relay ? With a board and also with a single speed fan on a fan limit switch also how would I wire the fan centre in? diagrams would be helpful.
|
||||
|
||||
|
The circuit board controls it all. All the safetys are built into the circuit board. If you are trying to bypass the circuit board forget it. While I am sure it can be done I will not begin to post how to do it because it is a violation of the listing see UL/CSA for further info on tampering with approved circuits. Just use the HUM terminal on the board.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The GFCI keeps tripping when we turn it on to the new hot tub. It is 4 wire 240v. Does anyone know why? We are following the wiring diagram and it does not seem to be a problem there.
I just bought a Habor Breeze ceiling fan & light kit. The ceiling fan has 1 black, 1 white, 1 blue and a green wire. The ceiling wires have two black, and two white wires. These wires were hooked to the light fixture I took down. Which wires do I use to wire my new ceiling fan & light up?...
I had an old General Electric Weatherington thermostat. I bought a new one yesterday and this is the old and new wire setup. OLD: O G Y R B W X2.
I have installed recessed lighting in part of my home and it works just fine but when I tried to wire the last two the lights stay on when the swith is off. The last two have a black, white, ground and red where does the red get connected two why doesn't this work?:mad:
I just swapped a 18 HP Briggs and stratton Motor over to another frame and the wireing harness will not match up. Should I take the ignition switch out and swap it over or does anybody have any suggestions.
View more questions Search
|
