Ask Experts Questions for FREE Help !
Ask
    OakwoodProp's Avatar
    OakwoodProp Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 30, 2008, 04:02 PM
    Intertherm Funace diagnostics code
    I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on the power. It will run for several days and then do the same thing. I have already changed the filter to a free flow filter. My Question is what does the 4 flashes indicate? Thank you in advance.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Nov 30, 2008, 06:28 PM
    Look on the blower door at the wiring diagram. It has a code for the number of flashes. On a mobile home unit it might be located elsewhere on the unit. Try to find it if possible,

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas funace/ac [ 2 Answers ]

Wiring schematic

Bootable USB IDEHDD diagnostics tool [ 2 Answers ]

My computer won't start up, even when I insert a bootable XP installation CD. My other computer has a IDE\Hardware Diagnostics tool that I can run from BIOS to detect if my hard drive is bad. I was wondering where I can find the HDD diagnostic tool that you run when your comp starts up, also how to...

Car Diagnostics [ 2 Answers ]

Is there a cd that can tell you your cars problems? If there is please show me the site. Thanks

System Diagnostics Tool [ 2 Answers ]

I was wondering if anyone could suggest a good system diagnostics tool that can be d/l from the web. I need one that will run at boot as I can't get windows onto a computer I am trying to repair. Preferably something that stress tests the system as well. Thanks.

Constant LED on diagnostics but. [ 3 Answers ]

... not sure why? I was troubleshooting an obvious ignitor failure on my Carrier furnace due to lack of heat, but while trying to create a cycle with another heat source it seems I've grounded out something causing a nice electrical pop, thus giving me a failure "refer to twinning kit...


View more questions Search