Ask Experts Questions for FREE Help !
Ask
    rondewil's Avatar
    rondewil Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 19, 2008, 06:10 PM
    Goodman Furnace Possibly Faulty Gas Valve
    Hello! This is my first time on this site. I have a goodman 56,000BTU furnace heating the upstairs to my home. Thermostat set to 85, inducer draft motor comes on, hot surface ignitor comes on, gas valve clicks,hot surface ignitor goes off and no flame, then blower motor starts. Cleaned flame sensor, took contacts off gas valve leads,put ends of voltmeter into contacts let furnace start it's cycle when gas valve clicked, I got 24volts then lost 24volts. I forgot to mention through all this no flashing led codes, just red non-flashing light indicating that everything is OK. I believe it's the gas valve,am I right?
    juggallojed's Avatar
    juggallojed Posts: 165, Reputation: 10
    Junior Member
    		  
    #2

    Nov 19, 2008, 06:29 PM

    First verify the gas pressure is normal
    And then that the valve is in the on position,
    If those are OK then I would suspect the gas
    Control to be at fault
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Faulty air admittance valve? [ 16 Answers ]

I own a manufactured home new in 2006. We are on city sewer and water. We have had problems with the check valve (air admittance valve) under the sinks. 2 have failed and let in sewer smell. Once the valve is changed the smell usually goes away. I changed the one under our master bath sink and the...

New switch, possibly faulty? [ 15 Answers ]

I have a double light switch (both Single Pole) which went bad... I picked up a new switch which looks to be the same (2 hot terminals, 2 neutral)... I hooked everything up the same way as the old switch (which also had 2 hot, 2 neutral lined up the same).. Now the switch turns on both lights at...

Replacement of a gas valve in a goodman furnace [ 1 Answers ]

I am replacing a valve in a 10 year old goodman furnace. The old valve has an orange lead in going to the "m" terminal and blue and green leads going to the "c" terminalfor a total of three leads . The new valve only has two terminals . How can I connect the new valve thomdunkneedshelp

Heil SP80 furnace malfunction - possibly the valve [ 3 Answers ]

The electric igniter does not ignite when the furnace should. The blower works fine, and is the first thing that goes on when the furnace is on for a heat. When I press on the wiring connector that goes into the valve the igniter then gets red hot and then the fire begins. I was wondering if...

View more questions Search