Must replace vent seals on gas all heater

fmmich Posts: 3, Reputation: 1

New Member

Nov 9, 2008, 10:34 PM

Must replace vent seals on gas all heater

Vent not properly venting on gas all heater

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Nov 9, 2008, 10:42 PM

OK so what?

Where is the brand and exact model number?

There could be a few different seals which one are you talking about?

Add your answer here.

Check out some similar questions!

Dryer Vent into Heater Vent? [ 6 Answers ]

Is it possible OK to feed a dryer vent into an already existing heater vent? I am thinking of installing a dryer in the middle of lower level two story house. The closest vent is the heater in the closet with the heater and water heater. Is it OK to run the went from the dryer into one of these...

OLD Carrier heater. Replace of fix? [ 2 Answers ]

Hello! I have a Carrier 58G01002A gas furnace in the basement. PG&E came out and said that the Limit Switch is out and needs replacing. A friend was by and said some of the ducting was patched with an asbestos material. Should I fix the limit switch and ducting and continue using the...

Replace LV1 with LV2 thermostat on baseboard heater [ 1 Answers ]

Ok here is my question I bought my house about 2 months ago. The lady painted over the wall thermostat to the base board heater. When I took the Cover off to remove the paint the knobs broke(I assume do to age) and the heat was constantly on. I removed the thermostate because it was summer. I am...

Do I have to replace gutter vent boots? [ 1 Answers ]

I had my gutter's cleaned and they said I needed 5 ventboots replaced for $525. What is a ventboot (wasn't home when they came)? Is it necessary? Does price sound reasonable? Can't seem to find anything in Google about gutter vent boots. Thanks.

Garage heater vent [ 3 Answers ]

I am installing a 45000 BTU space heater in my garage. This has a power exhaust. I am going horizontal with this about 3' to wall through wall then 1' past with cover outside. Do I have to use b-vent or can I use signal wall and a thimble through the drywall board and vinyl siding. I will have...