Ask Experts Questions for FREE Help !
Ask
    AdamO's Avatar
    AdamO Posts: 6, Reputation: 1
    New Member
     
    #1

    Oct 30, 2008, 10:55 AM
    Maytag Dryer will not stay running
    My Maytag Insignia dryer will not stay running after pushing the start button. After 30 seconds or so the dryer shuts itself off. Have tried cleaning all lint traps/filters that I could find. Any help would be appreciated.
    Flying Blue Eagle's Avatar
    Flying Blue Eagle Posts: 2,056, Reputation: 225
    Ultra Member
     
    #2

    Oct 30, 2008, 10:27 PM

    AdamO - Have you checked the high temp Protectopr that is on the out side of the heating element case, You will need a volt-ohm meter to check it to see if it is good:: another thing to check is the door switch, it may be going bad, whedn it goes completely bad it will not run at all until it is replaced :: IF this is not the cause then test the thermostate switch, start switch, and timer switch
    Good luck and GOD BLESS ::F.B.E.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Dryer stops after running about 15 minutes [ 1 Answers ]

I have a maytag dryer model LDE4914ACE. The dryer has a grinding sound when it starts up even if the drum is empty. The dryer will run for about 15 minutes initially then it will stop. I can start it up again immediately and it will run about 10 minutes and stop. I will finally get to shorter...

Mower will not stay running [ 3 Answers ]

I have a Briggs & Stratton riding mower. At first when it got too hot, it would die. Now, it seems like it's getting too much gas; I smell fuel. It won't start. Any thoughts?

Kenmore Elite Dryer Model # 110.63952101 won't stay running [ 3 Answers ]

I have a 3 years old Kenmore Elite Dryer (Model # 110.63952101). The dryer can be started and will heat, but shuts down after 1 to 2 monutes. It seems like a control problem. What do I need to replace?

Won't stay running [ 14 Answers ]

I have a 91 crx it sat up since may and I just put a d15b vtec in this past weekend. I sat the engine in and hooked up all appropriate connectors with the exception of two wires that is close to the intake manifold (yellow w/ green and a black) I have no clue where they go all I know is if you...


View more questions Search