 |
|
|
 |
New Member
|
|
Oct 25, 2008, 06:51 AM
|
|
Problems w/ a 20/40 pump
The well comes on and then the switch won't let the pressure get to 40 without the points sticking and clicking causing it not to cut off. This is an electric water well with a 20/40 pressure switch. What could be causing this?
|
|
 |
Uber Member
|
|
Oct 25, 2008, 10:08 AM
|
|
Sounds (obviously) like a bad switch. You can try filing the points with an emory board. Again, obviously, do this with the power off. But I wouldn't spend much time fooling with it when you can buy a new switch for twenty bucks and install it in an hour or less. You might want to also look at the small pipe leading to the switch to make sure it is not clogged with crud... happens rather often.
|
|
 |
New Member
|
|
Oct 25, 2008, 03:23 PM
|
|
We just replaced the sitch bought a brand new one still having this problem
|
|
 |
Eternal Plumber
|
|
Oct 25, 2008, 03:38 PM
|
|
What type of pump do you have? Try this. Let the pump pump up some pressure and shut the pump off at the breaker box. Does it hold pressure at the gage? Let me know. Tom
|
|
 |
New Member
|
|
Oct 29, 2008, 08:29 AM
|
|
Hi Tom no it is not holding the pressure. As soon as you cut it off ,it losing the pressure immediately.it returns to zero and it never makes it to 40 and it never disengages
|
|
 |
Eternal Plumber
|
|
Oct 29, 2008, 10:15 AM
|
|
 Originally Posted by dede34
Hi Tom no it is not holding the pressure. as soon as you cut it off ,it losing the pressure immediately.it returns to zero and it never makes it to 40 and it never disengages
You have just described a bad check or foot valve. Your pump will never quit or get up to rhe cut off point until you replace it. Good luck, Tom
|
|
 |
Uber Member
|
|
Oct 29, 2008, 04:16 PM
|
|
Good catch, SB.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Submersable well pump problems
[ 3 Answers ]
Hello ,
I have a brand new "flotec 1/2 horse 10 gallon per minute 2 wire deep well pump and a brand new square 'd" pump controler on a pressure tank .
The pump runs intermittantly . The controler is a 30 / 50 psi sometimes the press. Will drop below the 30 pound level & the contacts will...
Tempstar heat pump problems
[ 3 Answers ]
I have a tempstar heatpump that won't stop freezing up with the ac on hvac man said everything checked out but still have problem, also condensation is in the lower section under the coils. Got any ideas
Heat pump problems
[ 3 Answers ]
My upstairs unit is a heat pump. It is not yet 6 years old. Recently, it has been giving me problems. The blower will turn on, but it doesn't seem to put out heat or cold. Does that make any sense? We have had both cold days and hot days in the past few weeks. On the cold days, it can't seem to...
View more questions
Search
|