Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do I wire up my new AC condenser fan motor?
[ 7 Answers ]
My new AC condenser fan motor has an extra wire. What do I do with it? AC is a 1996 SEER 12 Rheem. New motor is an A.O. Smith 1/8 HP 208 RPM 208-230 volt. Old motor has 3 wires, black, brown, and orange. New motor has 4. Black, brown, orange, and brown with a white stripe. Does anybody...
Change 4 wire condenser motor to 3 wire motor
[ 4 Answers ]
I need TO know how to wire a condenser motor. The one I am taking out is a 230 volt it has 2 brown capacitor wires and a black and white. The one I want to put in is a 230 volt/5 mfd capacitor motor. This one has a red wire a black wire and only one brown capacitor wire. How do I retrofit this....
How to wire air handler to condenser
[ 4 Answers ]
Can you help with how to wire up a air handle and condensing unit
New A/C Condenser - What wire gauge for supply?
[ 1 Answers ]
Hi Experts- I am setting a new condenser unit for central AC and need to know the gauge of wire to run to the disconnect box. From the Manufacturer of the condenser: 13 SEER unit (higher efficiency) Minimum Ampacity: 14.5 25 Amp Breaker LRA 68
Where to land the yellow wire off condenser fan motor?
[ 1 Answers ]
I've recently tried to change out my condenser fan.My old fan was a G.E mod.#5kcp39gfp922ds it had a multi tap capacitor with a black wire leaving the motor and Landing on the defrost board at (DF2).The new motor I was given is a G.E mod.#5kcp39kgl733s.Both are the same 1/4hp, 825rpms, 208-230 V.... View more questions Search
|