 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wind Generator - 12v motor to 24 volt system
I want to tackle a home made wind generator (turbine). I will be using a small motor that puts out 12 volts. I have a 24 volt off-the-grid system. How would this be converted? Would the controllor automatically do that or do I need some sort of other converter?
Thank you, Kevin PS I have a Trace C60 controller. |
||||
Check out some similar questions!
Hello, we flooded our basement because of power outage and the sump pump stopped. I was thinking of having a battery generator (either 600w or 1500w that has an outlet so I can connect the outlet of the sump pump to it) I don't have any clue how long the battery will last so I thought I will...
I recently purchased a new german made lathe with a 1 and 1/2 h.p. single phase DC motor rated at 1400 watts at 2800 rpm, the plate on the motor says 60 hertz. 6 amp nominal consumption 230 volts. I also purchased a 110volt to 220 volt step-up transformer rated at 2300 watts. The lathe has a...
I have a 6 hp 230 volt air compressor motor that I have wired on a twin 20 amp breaker with a 10/2 wire. I cannot get the motor to start, I have took it off and had it checked and it works fine, just not when I wire it up in my garage. I do have power at my 10/2 wire, and cannot understand why it...
1. How I know that the operating voltage of small dc motor, where there is nothing written on. 2. why two 10nf capacitors are attached in searies with small dc motor and one 62 ohm resistor also.
I have a Dayton 1/3 H.P. motor Model no. 4M099C. It is a 220-230 volt motor. There are four wires coming from the motor. The purple is marked common, the black marked high, the blue marked med. And the red marked low. I want to connect these to run on 220. How do I go about connecting common and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
