Ask Experts Questions for FREE Help !
Ask
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #1

    Oct 5, 2008, 12:36 PM
    Where to ask detailed questions about auto repair.
    Is there another place that maybe sepcializes in auto repair help that a person can ask specific questions? I wonder if I can call the dealership and ask. I started to replace the thermostat on my 2004 Dodge ram 1500 but can't figure out the radiator drain cock. It turns 90 degrees but that's it. Also, I got to thinking maybe the waterpump is causing my problems of overheating. I'd just like to talk to someone about some problems.
    tickle's Avatar
    tickle Posts: 23,796, Reputation: 2674
    Expert
     
    #2

    Oct 5, 2008, 12:43 PM
    Calling the service dept at the dealership would be your best bet to get the info you want. But then, they may want you to bring it in. Sometimes its best to give up and save your sanity and let the experts do it. Sky high hourly rate of course, doesn't help. The parts are always quite reasonable though, because everyone makes them nowadays. They are rather generic.
    wildandblue's Avatar
    wildandblue Posts: 663, Reputation: 57
    Senior Member
     
    #3

    Oct 5, 2008, 12:46 PM

    The drain doesn't actually come out, just turns off and on like a faucet, the fluid will drain when you take off the radiator cap. The thermostat is usually inside the radiatror hose, you just loosen the clamps holding the hose on to remove it. The water pump makes a lot of noise if it goes on you. Radiator fluid could need changing or maybe you need a new cap.
    The dealer will fix your car and do it for free if it's a warranty repair and he will give you a free estimate, but they won't generally get involved in tutoring you. You could try calling a local college or an auto repair school or even take a class yourself. The sort of mechanic who has his own repair shop may have time to advise you
    wildandblue's Avatar
    wildandblue Posts: 663, Reputation: 57
    Senior Member
     
    #4

    Oct 5, 2008, 12:47 PM

    The drain doesn't actually come out, just turns off and on like a faucet, the fluid will drain when you take off the radiator cap. The thermostat is usually inside the radiatror hose, you just loosen the clamps holding the hose on to remove it. The water pump makes a lot of noise if it goes on you. Radiator fluid could need changing or maybe you need a new cap.
    The dealer will fix your car and do it for free if it's a warranty repair and he will give you a free estimate, but they won't generally get involved in tutoring you. You could try calling a local college or an auto repair school or even take a class yourself. The sort of mechanic who has his own repair shop may have time to advise you
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #5

    Oct 5, 2008, 12:55 PM

    The problem there is that much of the time the person you talk to at the service dept. is just a clerk and doesn't know anything about the vehicles. I'd like to talk to a mechanic. I also hate leaving my vehicle with them all frikkin day just to fix a small problem.
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #6

    Oct 5, 2008, 01:05 PM
    I turned the drain 90 degrees and took off the cap already and nothing. Maybe it's clogged? I need to replace the radiator anyway because it's leaking.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #7

    Oct 5, 2008, 01:09 PM

    The link below may help:

    https://www.askmehelpdesk.com/cars-t...tml#post235973

    After opening the drain, take a wire and poke it--corrosion or mineral buildup may be forming a blockage. If that's the case, you may want to replace the radiator. Be sure to only use a 50/50 mixture of G-05 antifreeze and distilled water. Mineral buildup is a common problem, which often leads to overheating.
    wildandblue's Avatar
    wildandblue Posts: 663, Reputation: 57
    Senior Member
     
    #8

    Oct 5, 2008, 01:11 PM

    The drain, if it is going across the pipe, that is closed, in line with the pipe, open.
    Be sure the car hasn't run where the fluid could be hot, you can just pull off the hose and have a bucket handy to let the antifreeze fall into. When you go to refill it later it will be obvious whether the draincock is open or not.
    At the bottom of the page, use the experts link to find one of AMHD's car repair experts even call them or send a private message if he doesn't respond the forum soon... it's a weekend during football season you know. Sorry I couldn't be more help
    And there he is, txgreasemonkey in the building!!
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #9

    Oct 5, 2008, 01:58 PM

    Dave, I read this about your truck in other threads and radiators are a big issue in overheating concerns.
    I'm not a Dodge tech, but I retain a lot from what I've heard before in this business. There's many that can be of help right here at AMHD. Hang with us.
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #10

    Oct 5, 2008, 02:43 PM

    Let me add some details to make sure you have all the info. I have a leak along the side of the radiator where the fins meet the side chamber. I'll replace the radiator in the next week or two. I don't know if it started leaking because the engine got hot or if it's even related to the overheating. I noticed the coolant was low and so I filled it up in the radiator and in the plastic reservoir. I drove it again and no real change. The engine temp seems to go up pretty quick and if I stay under 55 or so it stays pretty close the normal range but if I get on it or drive 70 mph or more it rises above the normal range and even will get near the red mark and I get a warning from the truck to check guages. Yesterday, it did it just driving 40 mph on a side road then the temp kept going down a little and back up to the hot mark Does this sound like a thermostat problem? The truck has 80,000 miles on it. 2004 Dodge Ram 1500, 4 x 4, automatic, 4.7 liter V8. Hope that's all the info.
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #11

    Oct 5, 2008, 02:46 PM
    Oh yeah, I did get the drain cock to open. I had to turn it over 90 degrees where it starts to move outward and opens up. Then to close it you kind of have to push in and turn CCW.
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #12

    Oct 5, 2008, 03:26 PM

    Txgreasemonkey, I bought Prestone Dex-Cool because the guy at Auto Zone said it was the same as what Chrysler was using and he had just gone through the same issue with another person with a different vehicle. I mixed it with tap water because I had no idea it mattered. When I change the thermostat and or radiator I will use distilled water. The 50/50 is only like $1.00 cheaper than the non-mixed so I think it would be cheaper to buy the distilled water. The truck takes 17 qts of coolant.
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #13

    Oct 5, 2008, 04:00 PM

    No Dave, it sounds like a flow problem. The core is partially
    Blocked or restricted. You must have maximum coolant flow upon higher demand of the engine.
    A stuck thermostat will go straight to hot in any driving. I'm not saying that's not at fault too.
    An inferred digital thermometer would show much cooler spots on the radiator core where the blockage is.
    Dave Ermeling's Avatar
    Dave Ermeling Posts: 173, Reputation: 3
    Junior Member
     
    #14

    Oct 5, 2008, 05:42 PM

    So, by replacing the radiator, that should hopefully take care of it? Or should I try the thermostat first? The thing is, I plan on replacing the radiator soon anyway. I noticed when I added coolant, it would only take just a little bit of coolant and then it took a while for it to go down enough so that I could add more. I could hear it kind of girgling really lightly.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #15

    Oct 5, 2008, 06:02 PM

    Use Zerex G-05 coolant on Chrysler products, not DexCool. DexCool is primarily for GM vehicles. My bet is that the radiator is the problem. Using DexCool in this application could create a HUGE problem. It's called "DeathCool" by some. Call a Chrysler service department for the recommended antifreeze or check the owner's manual--don't rely on a salesman.

    DexCool is an Organic Acid Technology (OAT) technology, while G-05 is a Hybrid Organic Acid Technology (HOAT). The wrong antifreeze can accelerate corrosion and affect gaskets. Read on the internet about the class action suits involving DexCool.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Auto repair [ 3 Answers ]

Besides checking the thermostat (replaced) why is my Jeep Grand Cherokee blowing cold air instead of warm or hot when I turn the heater on.:confused:

Sewer system repair questions [ 2 Answers ]

I am a first time homeowner and recently bought an older home, built in 1965 in Alabama. The house sits at the top of a hill. Several months after moving in, I noticed that black water seemed to come up out of the ground in and around the actual water meter. We hosed it down into the sewer, but...

Auto repair [ 1 Answers ]

Yes, I have a 1992 Lincoln Continental with a 3.8 L injected V6. The problem I'm having is the transmission shifts good but slow and only if I accelerate it will shift smoothly into next gear. Do I have a exhaust problem or vacuum loss at the transmission. ...

Auto Repair [ 2 Answers ]

God Bless You all, Merry Christmas and Happy New Year; If I don't chat with you all before the month is over with. Don't let nothing keep you from serving GOD.My Queastion, I have a 1999, 300m, which is out of timing, because of the belt teeth coming off. How do I set it?


View more questions Search