Ask Experts Questions for FREE Help !
Ask
    COLEMAN4552's Avatar
    COLEMAN4552 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 27, 2008, 09:05 PM
    Heat pump wiring
    I have a heatpump and gas furnace and wirinmg up a new thermastat honeywell visionpro8000 and will not turn the heat pump on possible wiring wrong? Colors are y-g-r-w-b and the heat pump wires are y-w-r-b-o
    The thermastat has on it y2-l-e-aux-s1-s2- left side heat pump and right side
    Heatpump has rc-r-o/b-y-g-c, the inside left for conventional are y2-w2-s1-s2 and right side rc--r-w-y-g-c and help wiring thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 28, 2008, 05:39 AM
    You will have to set it up as two stage heat.

    READ the manual that came with the thermostat. All information you need is contained in the manual/drawings.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Thermostat wiring for heat pump [ 1 Answers ]

I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?

Need wiring information on a heat pump to a oil furnace [ 1 Answers ]

All, I have had 4 people come out to fix the wiring on our newly installed system, the installer included. Here is the situation Basically the when our system calls for heat the blower comes on as soon as the heat, no matter if it is heat pump or Oil and also shuts off at the same time. When...

Heat pump wiring up to code [ 5 Answers ]

I had an eletrical surge (low voltage) burn out my 10 year old 3 ton Carrier compressor, a month ago. Electrican said it was caused by a power surge. Electric co states it was faulty in house wireing They told me that my 10 year old compressor was supposed to have a 35 amp rated circuit breaker...

Heat pump thermostat wiring [ 1 Answers ]

I have pored over the thermostat wiring messages on this forum, but I still have a question. I am installing a RiteTemp 8085C to replace a Janitrol thermostat for my Goodman heat pump. The old thermostat was wired as follows: Red to R Orange to O Yellow to Y Green to G Blue to C White...

View more questions Search