Ask Experts Questions for FREE Help !
Ask
    redraven's Avatar
    redraven Posts: 13, Reputation: 1
    New Member
    		  
    #1

    Sep 15, 2008, 12:53 PM
    Motion flood light replaceing
    I have a motion sensored flood light that I have to replace. Is this easy? When it comes to the "wiring" what do I do? I do not have a breaker to turn the power to it on and off also. Thanks
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Sep 15, 2008, 02:32 PM
    You must have a breaker for the light. Installation is fairly simple and straight forward. Light should come with instructions. You can always get help here.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Adding a motion sensor to 3 way outdoor flood lights [ 2 Answers ]

First, thanks in advance for your time. I have two 3-way switches in my home at opposite ends of the house that control two different flood lights outside on the same circuit. I bought and hooked up a motion sensor to one of the floods thinking that when it is triggered it will turn both sets...

Hampton Bay outdoor flood light (motion/optical) [ 1 Answers ]

My HB flood lights stopped working recently, but if I turn the unit to "test", wave my hand in front of the sensor, the lights pop on. Turning it back to 1,5, or 10 minute timer delay does not work, even in the dark. Faulty opical sensor? Would that prevent the unit from operating in timer mode?

Light switch and flood [ 1 Answers ]

Well its me again I would like to say a big thanku to wally for all the help you have tried to give me the problem is now sorted it was the flood to the bathroom that caused the problem the light switch I have know installed and the wiring has dried out and electric back on.where I come from in...

Wire a motion detector to flood lights [ 1 Answers ]

I need help to wire a motion detector to my outside flood lights that can be turned on from Three locations.

Outside flood light wiring [ 2 Answers ]

I would like to add outside flood lights to my metal workshop building. Since all the wiring will come from the interior of the building, do I need to use special water tight wiring to install the flood lights on the outside of the building or can I use the flex cable I have been using to wire the...

View more questions Search