Not your question?
Ask your question
View similar questions
Check out some similar questions!
Installing Floor Registers to Draw Basement Heat
[ 7 Answers ]
I have a 2-story colonial in CT. The heating system for the house is oil-fired (forced hot air). A couple of years ago, I finished the basement and made it a den. Since there was no heat in the basement, I installed a propane heater made for rooms - the one I installed (a Rinnai) is actually rated...
Are just two AC returns adequate for this floor plan?
[ 2 Answers ]
Hi, I am building a new home, and would like some advice on getting the AC system right. The builder's plan has just two AC returns in this 3600 sq. ft. single story house. In the floor plan link below, there is one return outside the guest bedroom, and another one in the hall outside the...
Roughing in drain lines in basement floor
[ 1 Answers ]
Please help on roughing in drain lines in basement
Running water lines to 2nd floor
[ 2 Answers ]
Hello, I would like to put in a 2nd full bath on the 2nd floor of our cape cod. Currently, there's a 4" cast iron DWV that runs up a channel to the 2nd floor and then vents out to the roof. I was wondering whether it is possible to use flexible copper tubing to run the water lines up that... View more questions Search
|