Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Replacing a shower.
 [ 4 Answers ]
 Hi. I'm replacing a shower that was a one-piece moulded unit. It leaked, so I bought a replacement unit to install. All is fine, except when I go to connect the drain. The trap and drain is 1 1/2" pipe and there is a nut at the top of the pipe. The drain that I have is for a 2" pipe and is... 
Need help replacing toilet flange
 [ 9 Answers ]
 I'm working on a job in a 60's condo that has a cast iron toilet flange attached to the pipe of the same material. It is about 2" above the subfloor, somebody elses crapy botch job that I'm fixing, and I need to bring it down to the new level. How do I remove the flange without damaging the pipe to... 
Replacing tub with a shower pan
 [ 1 Answers ]
 I am thinking about replacing a tub with a shower pan. Can I get a right drain shower pan and connect to the existing 1.5 inch ABS drain pipe? If so is there a kit available? How does the pan drain connect to the existing drain line? Or is it a matter of going from 3 inch to 2 inch to 1.5 inch? Are... 
Replacing toilet floor flange
 [ 3 Answers ]
 I was replacing my toilet and found that my flange was rusted so much that I couldn't get the flange bolt on one side to lock into the flange so I must replace the flange. It's made of metal with ABS and obviously is glued into the ABS sewer pipe riser. I'm assuming that I need to get underneath... 
Replacing a toilet flange with a lead connection
 [ 6 Answers ]
 
I am about to pull up my old toilet and take a close look at what's underneath. I am also going to go over the original plank sub-floor with fresh 3/8" ply (followed later with thin lauan for eventual linoleum) there is a visible floor patch from an old repair. Given the fact that there has been a... View more questions Search 
  |