[cpfacundo]

I have a question on my above ground pool the gauge is at zero even when back washing never movers want to know why it would not be working?

Thank you
Patricua

[albinfla]

There is likely something in the gauge. If you have a sand filter, it could be a piece of sand. Or, just a piece of some type of debris.

It is very easy to replace. Turn off your pump, unscrew the old gauge. Buy a new gauge buy the same pressure range if available (likely 0-30). Be certain to put a little teflon tape on the threads of the new one... 2 wraps of tape only.
Good Luck,
Al

[cpfacundo]

I had someone come out and it ended up being fan that spends the water and there was a lot obstruction we cleaned it out and know I'am getting a reading thanks for your help.

Thank You
Patricia