I have a question on my above ground pool the gauge is at zero even when back washing never movers want to know why it would not be working?

Thank you
Patricua

There is likely something in the gauge. If you have a sand filter, it could be a piece of sand. Or, just a piece of some type of debris.

It is very easy to replace. Turn off your pump, unscrew the old gauge. Buy a new gauge buy the same pressure range if available (likely 0-30). Be certain to put a little teflon tape on the threads of the new one... 2 wraps of tape only.
Good Luck,
Al

I had someone come out and it ended up being fan that spends the water and there was a lot obstruction we cleaned it out and know I'am getting a reading thanks for your help.

Thank You
Patricia