Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New well pump vs. New holding tank
[ 2 Answers ]
Hello all. This is our first house with a well & septic system. The well pump(submerged) is approximately 18 years old and has never been replaced to my knowledge. We are now experiencing very low interior house pressure when outside spigot is in use or when washing clothes, showering, etc....
How much water should be in the holding tank of a well?
[ 5 Answers ]
I live in the oldest house in the world - 1861. From what I can tell the plumping was put into the house in the 1950s but I assume the well has been there since forever. Anyhow - we have had a lot of issues over the past 20 years that we lived there. We had a plumber out that pulled the pipes...
Washerless shower diverter valve malfunction
[ 4 Answers ]
The hot/cold mix of my shower began to malfunction a week ago. I can no longer get water hotter than warm. The main component of the valve is a 2-piece plastic part and one of the small rivets came out resulting a slight separation. This part has two ports with spring loaded washers that press...
Heil SP80 furnace malfunction - possibly the valve
[ 3 Answers ]
The electric igniter does not ignite when the furnace should. The blower works fine, and is the first thing that goes on when the furnace is on for a heat. When I press on the wiring connector that goes into the valve the igniter then gets red hot and then the fire begins. I was wondering if... View more questions Search
|