Ask Experts Questions for FREE Help !
Ask
    gmckellips's Avatar
    gmckellips Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 31, 2008, 02:34 PM
    well pump not working
    My pump is not working. The logo on the storage tank is WELL X TROL. I have read about priming the pump but I can't figure out how to do that on my system. Please Help.
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
     
    #2

    Jul 31, 2008, 03:53 PM
    If your pump is above ground, then priming is simple. Look at the top of the pump casing. You will see a plug or a pressure gauge. Remove it, pour in water until it overflows, replace it, and turn the pump on.

    If it's a submersible pump, then you don't prime it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water Pump not working [ 2 Answers ]

We had cold weather and we lost our water. It still hasn't come back. We replaced a blown fuse but it still doesn't work. Does the pump come on even if it needs to be primed? It makes no sounds. Does this mean that the motor is burned out? Or do I just need to prime it? Thank you.

How to tell if circulating pump is working [ 2 Answers ]

I have and older Furnace with Hot water Cast Iron radiators (2 floor, 1300 sq ft house). Had to turn on furnace for first time over weekend and it took about 50 min to get the temp from 63 up to 66. The radiators heat unevenly and I was listening for the circulating pump to go on so I could bleed...

Well Pump stops working [ 4 Answers ]

Anything to do with plumbing is my worst area to deal with. Twice in the past week our Goulds above ground jet pump suddenly stops it's on and off cycling while running the water and the water quickly ran to a trickle and stopped. After about 2 minutes it suddenly started again, but with spurts of...


View more questions Search