Ask Experts Questions for FREE Help !
Ask
    dd52655's Avatar
    dd52655 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 12, 2008, 10:31 AM
    Whirlpool ultimate care II won't empty or spin
    My washing machine washes fine but won't empty or spins just hums... any ideas??
    Thanks for any help
    Credendovidis's Avatar
    Credendovidis Posts: 1,593, Reputation: 66
    -
    		  
    #2

    Jul 12, 2008, 04:22 PM
    The spinning can not start until the drum is empty.
    So the problem is in the pump section!

    First : CLOSE the water inlet tap.

    Remember that your drum is full of water : remove the pump hose from pipe and put into drain or bucket. You do not want all that water to drain over your floor. Make sure the drum drains properly (if too slow check later also the hose for blockage).

    Than check the water pump : open up the pump cover (at bottom front). Be ready to collect remaining drain water!! Remove any obstructions. Check also the access hole to the inner drum.

    Close the pump cover.
    If you want to check the hose do it now, by blowing through the outlet section towards the washer. When clean , re-install the pump hose.
    Open the water tap. Check the washer and pump operation.
    If you still have a problem - and have a multi meter - you can do more tests if you want.

    Just let me know by private mail (click on my handle and follow instructions) and I will return here to reply.

    Success !

    :)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool Ultimate Care II washer will not drain [ 13 Answers ]

The washer runs through the wash cycle but when it is suppose to drain it does nothing. There is no hum just dead. I drained the tub out and disconnected the hose from the back thinking the drain was plugged. But when I did this the rest of the water from the tub drain out no problem. I'm...

Whirlpool Ultimate Care II LSQ9010PW6 [ 1 Answers ]

Hi I am trying to find out what could be cause my washer to be draining its water during the agitate period. When it is suppose to be shaking and washing the clothes it is draining the water and by half way through the agitate process there is no water left in the washer. What could be causing...

Whirlpool Washer Ultimate Care II [ 1 Answers ]

Our Whirlpool washer has developed a strong, musty odor. We think it is coming out of the hole in the agitator. Can the agitator be taken off? What could be making a strong smell? I have tried running clorox through, and it doesn't seem to help. Thanks

Whirlpool Ultimate Care AL5143VW0 stalls [ 2 Answers ]

My Whirlpool will fill and agitate then stall before it drains and spins. It is so frustrating to go switch clothes to the dryer and the washer is still full of water. This happens most of the time on the first spin sometimes on the second spin and sometimes not at all. I am going to replace the...

View more questions Search