Ask Experts Questions for FREE Help !
Ask
    affvince's Avatar
    affvince Posts: 4, Reputation: 1
    New Member
     
    #1

    Jul 7, 2008, 07:07 AM
    How to move a water closet drain 4 feet on a 2nd flloor
    I have searched this site and found what I think is the answer to my question, but I still am not quite sure. I am remodeling my master bath on the second floor of my home. I need to move my toilet approximately 4 feet from it's current location. The current drain for th toilet goes horizontally down to the basement through a wall. My question is: Is there enough room between the floor and the 1st floor ceiling (12"') to accomplish this?
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #2

    Jul 7, 2008, 07:37 AM
    Sure, there is enough space to move it 4'. Don't worry about vertical part. Cut your existing toilet pipe between hubs, install coupling and extend in any direction you wish. Then, install "toilet bend", "closet ring" and you are finished. Don't worry about moving vent or installing new one. Since you moving it only 4' away, existing drain will vent your toilet just fine.

    What type of pipes do you have? PVC, ABS or C.I.
    affvince's Avatar
    affvince Posts: 4, Reputation: 1
    New Member
     
    #3

    Jul 7, 2008, 07:48 AM
    Hi Milo:

    Thanks for the quick response. It seems too easy. I have all PVC. My home is about 20 years old.

    To be clear: Is there enough room to put in (2) 45 degree bends and a straight pipe within the distance between the 1st fllor ceiling and the 2nd floor ?
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #4

    Jul 7, 2008, 07:51 AM
    Yes, 12" ( actually 11.5"), the size of your joists, is wide enough for moving your toilet pipe.

    PVC is easy to work with. HD and Lowe's carry PVC pipe and fittings.
    affvince's Avatar
    affvince Posts: 4, Reputation: 1
    New Member
     
    #5

    Jul 7, 2008, 07:58 AM
    Thanks again!

    You've made my day! I was envisioning having to run a new pipe through the wall because I though that the pipe needed a strighter run to eliminate clogs.

    I'm ready to go.

    Thank you
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #6

    Jul 7, 2008, 08:24 AM
    3" pipe should have 1/4" slope per foot . 4" pipe should have 1/8" of slope per foot.

    Leave existing horizontal to vertical connection the way it is. Just attach to it. Extend new pipe and bends to your new location. Glue all together.


    If you have to horizontally penetrate ceiling joists with your new pipe than Drill. If you don't have such a large drill bit and have to cut, than pre-drill with small drill and neatly enlarge with sawzall to the required size.
    affvince's Avatar
    affvince Posts: 4, Reputation: 1
    New Member
     
    #7

    Jul 7, 2008, 09:17 AM
    All good advise! Thank you!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can closet flange be used as drain fitting. [ 1 Answers ]

Hi, I have a 4" cast iron drain pipe flush with my basement concrete floor that was used for a toilet. The pipe does not have a hub connector. The toilet was installed without a closet flange. I want to use this drain for a bathroom being added on the floor above. Is it possible to use a PVC Twist...

Converting toilet closet for shower pan drain [ 2 Answers ]

I have a distribution warehouse where I want to install a shower over a existing toilet drain. I was thinking of a shower pan with a off set drain directly over the toilet sewage line. Is this possible?If possible what type of connection is code and what problems may I run into. ...

Move toilet 3 feet over concrete slab, building platform [ 6 Answers ]

I know there have been many other posts about moving toilets, which have been quite helpful, but I'm posting this to get additional info for my particular project. The renovation is for a 60"x90" bathroom that currently has an unnecessarily large vanity and the toilet as a focal point. See...

Move toilet 4 feet [ 11 Answers ]

Hi, I have a second floor bathroom that is 6 feet wide. Toilet is on left side wall and looks to be a foot away from wall. I want to move toilet to the right side wall. So this would require a move of about 4 feet. Two things need to happen of course: water supply must be available and the...

Drain line 5 feet long going into main stack [ 2 Answers ]

Hello, I am installing a washing machine drain line using 2" ABS pipe. The drain line will be installed within a 5 foot horizontal run going into the main stack. Within 5 feet of the main stack, do I need a vent line? Thanks for the help.


View more questions Search