Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing a Saddle Valve
[ 3 Answers ]
I Have a saddle valve that allows water flow to a furnace humidifier. I can not shut it off nor turn the valve stem. Can a saddle valve be replaced or does one install a new piece of copper pipe and then install the valve?
Replacing shower/tub valve body
[ 2 Answers ]
I am remodeling my bathroom. I need to replace the shower/tub valve body. My galvanized pipes are rusting out. I have a three handle system. Hot, cold and diverter. I have two bathrooms which are built back to back. I have one set of incoming water lines. A previous owner repiped and brought...
Replacing Shut off valve on PVC
[ 6 Answers ]
My water line going to the dishwasher was leaking so I replaced it. Now I've figured out that the shut off valve is leaking at the nut that goes over top of the PVC pipe. I bought a replacement valve but can't figure out how to get the old one off the PVC pipe. I'm assuming it has glue/cement...
Replacing Gas Oven Valve
[ 2 Answers ]
I recently had an employee from the local gas company in my kitchen and he looked at the shut off valve for my gas oven. He suggested I call a plumber and change the valve because it was very old and prone to failing. What are the best types of gas shut off valves that I should ask a plumber to...
Replacing Shower Valve Stems/Seats
[ 1 Answers ]
Since the valve stems don't have a brand name anywhere on them I am concerned I may get the wrong size or thread type. Are plumbing parts consistent all across the board? I just can't seem to get this drip to stop completely. I can slow it down, but the washer ends up getting wrecked in about 3... View more questions Search
|