Ask Experts Questions for FREE Help !
Ask
    gorilla paw's Avatar
    gorilla paw Posts: 2, Reputation: 1
    New Member
     
    #1

    Jun 21, 2008, 06:31 PM
    Washer door won't unlock
    The door on my Maytag Neptune Washing Machine (model #MAH8700AWW) is locked and will not release. I cannot find any sort of manual unlocking device or system. Help please, all my favorite clothes are trapped inside!

    Thanks!
    gorilla paw's Avatar
    gorilla paw Posts: 2, Reputation: 1
    New Member
     
    #2

    Jun 21, 2008, 07:53 PM
    I found the mystery unlock lever! After removing the top, the console and the front panel, I was able to access the door switch. At the very bottom of the switch, there is a ring shaped lever which pulls straight down. This disengaged the door lock. I didn't find any obvious defect, but I will most likely replace the switch. Suspiciously, the service manuals do not mention this means of opening door, and do not even give you a clue about accessing the switch, instead they recommend a service call. Which would have cost me some bucks!

    It took me about 30 minutes and a phillips screw driver to fix it.

    Best wishes to all!
    alabou's Avatar
    alabou Posts: 1, Reputation: 1
    New Member
     
    #3

    May 10, 2011, 07:05 AM
    Wow you the first one that got it right I have look all over the internet and you have the answer... mine says and so it's the pump maybe but my clothes was still in the washer so...

    I didn't pull the front panel I just slid my arm from the top and push down the rod/arm or whtever its call

    Thanks
    inspector's Avatar
    inspector Posts: 2, Reputation: 1
    New Member
     
    #4

    Dec 29, 2012, 09:45 AM
    I got the top and the console off; however, the front panel is a little difficult. I have removed the four screws at the top of the front cover but the front cover still won't come off. What do I do now?

    Thanks,
    Baldy

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How can I unlock the control lock on my Kenmore washer? [ 18 Answers ]

How can I unlock the control lock on my Ken,ore washer?

Maytag washer door lock [ 5 Answers ]

I have a maytag front load washer and after the wash cycle the door lock light is on and won't release. Anyone know how to release it? Thanks very much.

Removing Maytag washer door boot spring [ 1 Answers ]

I have a Maytag Model MAH6500AWW with a door boot that has a slit cut into it and leaks. I can disassemble the machine down to the point of removing the tub spring that applies tension to the boot cable holding the door boot onto the tub. There is a lot of tension on that spring. How do you...

Garage door opener making loud noise and door won't go up [ 1 Answers ]

When I pushed the button to open my mom's garage door, the door went up about an inch and made a loud banging noise like a machine gun. We got the door to open by pushing on the button and pushing up on the door. The noise is coming from the part in the middle of the garage door that goes down...

How can I unlock the control lock on my Kenmore washer? [ 1 Answers ]

How can I unlock the control lock on my Kenmore washer?


View more questions Search