Ask Experts Questions for FREE Help !
Ask
    wmcrinc's Avatar
    wmcrinc Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 10, 2008, 10:11 AM
    Bryant 90+ control board relocation
    Hello, I am replacing the control board in my 10 yr old Bryant 350MAV furnace. I was given a kit to relocate the control board "into the blower area" I can't believe I'm suppose to install next to the main blower. Let's face it, even with a regular new filter, it's dirty in there and there is no cover for the circuit board. I'm I wrong about the instructions? Should I just put it back where the original was (on the left side wall next to the vent fan)?
    Thanks, Kevin C
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jun 10, 2008, 12:35 PM
    They are looking to cool the components on the circuit board and preventing overheating which is sudden death for the control board. Carrier/bryant spend millions of $$$$$ in there engineering department every year. Put it where they say to put it or risk failure of the board. They know much more about what they are talking about in the instructions that you do.

    If the inside of the blower cavity is dirty pull the blower assembly and clean the interior of the unit and the blower motor and wheel assembly. This is standard service and should be done every few years.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #3

    Jun 10, 2008, 03:34 PM
    Clean it,, and make sure you keep clean filter,, and it shouldn`t get that dirty,,

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier/Bryant Furnace control board . [ 9 Answers ]

I replaced Carrier/Bryant board and the led is flashing rapidly.. what can be wrong? It looked like there's problem with polarity,but everything is fine, the led is still flashing.. uff.. Led Code: Continuous on rapid flashing-Line voltage 115 polarity reversed.If twinned,refer to twinnig kit...

Bad Furnace Control Board? [ 6 Answers ]

I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...

Bryant Evolution (carrier infinity) Control and Honeywell Fresh Air Vent. [ 2 Answers ]

I have an Bryant Evolution system installed. This is the same as a Carrier Infinity system. This consists of a 355MAV furnace, a 598B a/c And SYSTXBBUID01 Evolution control. Also installed in this system is a Honeywell Y8150 ventilator and a Honeywell HE440 steam humidifier. The...

Can I install a fan control board? [ 3 Answers ]

I am a broke, but resourceful guy who got a quote from an HVAC company to install a new fan control board in my Ducan furance for $420. He wrote to part numbers on the estimate. Ducane part 20430801 (Ducane) & ST9160B1076 (Honeywell). He told me it would take him 1-1.5 hrs to install. To make...

Furnace control board [ 2 Answers ]

Can the board be repaired or do I need to replace it


View more questions Search