 |
|
|
 |
New Member
|
|
Apr 29, 2008, 06:37 PM
|
|
Mixing morter
I need to know how much sand to mix with one bag of type n morter?
|
|
 |
Senior Member
|
|
Apr 30, 2008, 06:32 AM
|
|
Type N— One part portland cement, one part hydrated lime or lime putty, and six parts sand; or, one part type II masonry cement and three parts sand. Type N mortar is suitable for general use in above-grade exposed masonry where high compressive or lateral strength is not required.
Copied from here:
Mixing Mortar
|
|
 |
Home Repair & Remodeling Expert
|
|
Apr 30, 2008, 07:34 AM
|
|
Last time I looked the proportions are all listed on the back of the bag. Can you explain what you are doing and why you choose Type N?
|
|
 |
New Member
|
|
Apr 30, 2008, 11:19 AM
|
|
 Originally Posted by ballengerb1
Last time O looked the proportions are all listed on the back of the bag. Can you explain what you are doing and why you choose Type N?
I am setting up a block wall under my mobile home I have #80 lb bags of type N morter mix but did not know how much sand to mix with each bag I am laying 6 inch block with it. Thanks RUSS
|
|
 |
Home Repair & Remodeling Expert
|
|
Apr 30, 2008, 03:52 PM
|
|
OK sounds like you are just using up what was at hand. Type N is not the most convenient since you can buy readi-mix mortar and just add water.
|
|
 |
New Member
|
|
May 1, 2008, 05:51 AM
|
|
 Originally Posted by ballengerb1
OK sounds like you are just using up what was at hand. Type N is not the most convenient since you can buy readi-mix mortar and just add water.
Well I don't know what you mean about just using up what's at hand but I still don't know the answer how much sand vs morter? Plus the ready mix was a little costly but thanks anyway. RUSS
|
|
 |
Home Repair & Remodeling Expert
|
|
May 1, 2008, 08:40 AM
|
|
Maybe I misunderstood your wording when you said you had a bag. I figured you had the bag for a while and were just using it up. Yes the readi-mix is more costly but you don't have to go get sand and lime and mix it yourself, you are paying for the covenience. Doesn't amricca answer your proportion question in post #2. Type N is not as strong as some others. Keep this cahrt for future reference. Masonry
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Mixing old and new wire
[ 8 Answers ]
Live in a circa 1940's home with old non-grounded NM cable, cloth outer shell, insulated wires. There are currently 14 outlets on 1 circuit, in addition to 5 ceiling lights. Obviously the circuit is overloaded.
I'm planning on running 3 new circuits (living room, bedroom, dining room are...
Morter consistency
[ 1 Answers ]
Using 80 lb. bags of "type N" mortar for Ledgerwood stonework, which will be applied to a vertical wall of concrete, what should the consistency be? How much water is too much?
Paint mixing
[ 1 Answers ]
What colour can I mix with terracotta to make a dark mustardy yellow colour please
Morter removal
[ 1 Answers ]
How do you remove morter from fire place brick pavers .
Morter vs Sand Mix
[ 3 Answers ]
What's the difference between morter and sand mix? While I'm asking there is type N and Type S morter. My application is building a concrete shower curb and base, to eventually be tiled.
Thanks
View more questions
Search
|