Search:
Type: Posts; User: caimakale
Search:
Search took 0.02 seconds.
-
If I was to do this, I would add a separate box with a GFI receptacle.
I didn't think about the 30 amp breaker that controls the A/C circuit, it's a very good point. I can add a breaker in my...
-
Is it within code to tap into an A/C disconnect box (240v) or hot tub disconnect (240v) and add a 120v GFCI outlet?
I know it can be done, but there may be potential risks that I am not aware of. ...
-
You usually have to erase all the codes in the garage door logic board usually located on the back of the motor.
The openers I am familiar with are fairly simple. You push and hold the button on...
-
I am building a cinder block wall and will be stuccoing the exterior part of the cinder blocks. On houses, a vapor barrier is put up, then chicken wire, then a base stucco coat. After it has cured,...
-
I went to the ICC website because I need to get an IBC code book. I have no idea what I would need though. They have the I-Code set for $680.50 but I am wondering if that is overkill.
I do a...
-
There is a locking coupler on the Whirlpool washing machines that locks when it kicks into spinning cycle. I am guessing here, but if you try and run it without any clothes in it, it will probably...
-
It could be several problems. One problem could be the timer. More likely though, it sounds like the motor/pump is ceased or has gone bad. The water is filled through a separate valve and has...
-
That's what I was afraid of. It wouldn't be a big deal but man copper is expensive right now! I have lots of 14 gauge, but no 12 gauge... go figure. ;)
-
I know that a 20 amp breaker and a GFCI plug are required in a bathroom. Does this mean the wire size has to be 12 gauge or can it be 14? If I wire the bathroom lights on the same circuit, can I...
-
I am building my basement right now and have been reading about wiring and circuits. I thought I had everything figured out for my basement until I started looking into my lighting circuit today. I...
|